Question about Mitsumi (cr485gte-bk) CD-RW Burner

1 Answer

Tray on my CD-RW drive is not open when i press eject button how I can solve it permamently.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 29 Answers
Re: Tray on my CD-RW drive is not open when i press eject...

You should know how to open the case, then replace a worn belt inside.

Posted on Jan 19, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

When I Press Eject button the tray does not open. It is also taking too much time during booting.

Use a pin and insert in the emergency eject hole (usually in the center below the tray) and then you can eject the drive tray with force. It is time you planned for a new drive.

Untill then please insert a music CD into the drive tray and leave it there, this will ensure the eject will work (most of the time). Booting time will definitely increase if the drive has issues, reading or responding.

Feb 03, 2011 | ASUS DRW 24B1ST Disk drive DVD RW ( R...

3 Answers

The DVD tray doesnt eject

either it is the ribbon wire, the motor that ejects the tray or the belt that connect the tray and motor is the problem. In case the above three are fine, replace the drive as the sparking might kill your moterboard.

Jul 08, 2009 | Compaq (CDD480172) CD-RW Burner

2 Answers

My cd rom tray does not open

hit it on top of it or the casing and it will open. but this is not the good way but i have the same problem i use this

May 20, 2009 | LG (GCC4522BK) CD-RW/DVD-ROM Combo Drive

2 Answers

What can i do to open the door on my ez-dub

HI Buddy If your cd drive not opening no prob haah,, i have solution to open this, near by your cd room button there would be whole tiny whole ok, you have to do that when u pressed the button same time your have to entered the pin in to whole then your cd drive will come out easily.

if u will suceed then reply me plz ok best of luck.

Feb 28, 2009 | Lite On LH-20A1H DVD RW Dual Layer Burner

1 Answer

Tray will not eject on LTR 16102B CD-RW

Most likely due to a worn belt. You can use a paper clip in the manual eject hole while pressing the button repeatedly to get it open. The belt or the drive will need to be replaced.

Jul 07, 2008 | Lite On LTR 16102B CD-RW Burner

1 Answer

Failure opening the tray

do 1 thing,take a pin and insert it in the small hole below the tray
and then press the eject button

Jun 04, 2008 | Samsung (SHM522CBEWN) CD-RW/DVD-ROM Combo...

3 Answers

Cd tray eject problem

the carriage unit (tray) is braoken, you can open it up and use plastic weld to fix the broken off part or you can change the tray or buy a new one :)

Dec 22, 2007 | Samsung (DSSMBK482448) CD-RW Burner

1 Answer

Cd rom tray open problem

normal problem for samsung cd drives . clean the rails of drives that which tray is commin out . it mainly caused due to the change ina laaingnment of drive tray

Dec 04, 2007 | Samsung (DSSMBK482448) CD-RW Burner

2 Answers

CD Drive not Ejecting properly

Hi, Since the warranty period has expired I will assume that the CD/RW has been in use for some time. Normally a small belt powered by a motor drives a gear that slides the tray out. Sometimes this belt is loose, warped or plain cut. Replacing the belt should solve the problem. You have to open the CD and it is near the front just below the tray. In other instances, the grease on the toothed railing at the sides and/or underneath the tray gets gummed up, cleaning and repacking with new light grease should take care of that. Rarely (but still does happen), the motor itself burns up and replacement (if you can get the part) is in order. An interim fix is to push a small straightened metal paperclip at a small hole below the tray cover/lip and slightly push till the tray partially opens. You can then manually pull it out. Hope this be of some help/idea to you. Good luck and kind regards.

Aug 27, 2007 | Samsung (SH-W08AENB) DVD±RW Burner

2 Answers

CD-RW Problem

There some few tips you can try. Power down the computer then open the cd tray by inserting a sharp object in the small hole near the tray. Look for this hole, then using the sharp object push it pretty hard. With the other hand try to pull the tray out. Once you've pulled it power on the computer (with the cd-rw's tray opened) and watch what the cd-rw is actually doing now. If after it retracts the tray it is doing the same, you will need to dissasemble it. If you are willing to try this, please post another message and also specify there what did the cd-rw drive do when you've applied the method i've told you before.

Mar 11, 2007 | Lite On (LTR-52327S/5238S)...

Not finding what you are looking for?
Mitsumi (cr485gte-bk) CD-RW Burner Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsumi CD & DVD Burners Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers


Level 3 Expert

6993 Answers


Level 3 Expert

56836 Answers

Are you a Mitsumi CD and DVD Burner Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides