Question about Hitachi 53UDX10B 53" Rear Projection Television

1 Answer

Hitachi 53SDX89BA - only sound coming not picture

After it is on, only the sound is coming, the picture is not coming.
7 years old.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Hitachi Master
  • 5,138 Answers
Re: Hitachi 53SDX89BA - only sound coming not picture

You may have a shorted hori output transistor or open pico fuses they look like resistors in away but they are green or yellow looking some are 5amp or 6amp fuses if they are bad replace with same value.

Posted on Jan 17, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

60 inch hitachi hd 11 years old got real blurry then weny off, makes a sound like it is going to come back on but has no picture or sound,

If you mean it got 3d looking or colors skewed etc the problem is in the convergence circuit----got a model number?

Dec 02, 2012 | Hitachi Projection Televisions

1 Answer

Hitachi 65f59a

most likely a powersupply problem, check the fuses for a start.

Jun 07, 2008 | Hitachi 65F59 65" HDTV

1 Answer

Have a Hitachi 53sdx89BA Rear Projection TV. Turn on TV and red power light illuminates. No picture, but have sound. Check PC board in back and red led is flashing and green leds are lit. It was working...

Discharged Flyback Transformer. Removed main pc board from bottom of TV and flipped over, no apparent damaged components or blown board traces were found. Noticed a lot of flux in various areas on the board that seemed unusual (maybe TV was worked on before as I bought a showroom demo at Circuit City). Used a plastic screwdriver to remove all flux between connections on ICs, Transformers, Flyback Transformer, and various other components. Cleaned all debris, dust and crud accumulation (TV is over 10 years old and there was alot around the Flyback Transformer) from both sides of board using a lightweight paint brush.
Used a magnifying glass to check all solder joints for possible cold solders and found none. Did the same for Power Supply Board. Checked various ICs and Power Transistors for opens or shorts (in machine) and they seemed fine. Reinstalled boards, said a few Hail Mary's and fired it up.

The protector Led no longer flashed under power and lo and behold I got picture and sound!

I cleaned the lens on the projectors (again 10 years of dust accumulation) did a magic focus adjustment and it works fine!

After reading other fixes, I fully expected it to die after 10 minutes so I left it on all day and against all odds it still works.

What was the fix......Dirt buildup on and around Flyback and other components,,,,,,Flux conducting electricity between contacts on Flyback and other components.....or oxidation on connectors between Power Supply and Main Board.....I don't know.... all I know is that for the moment I saved around $ 300 - 400 in repair bills by doing it myself.

Feb 01, 2010 | Hitachi 53SDX89B 53" Rear Projection...

1 Answer

TV turns on no picture

Symptom: DEAD
Cause: I901,D907

If you need the full downloadable service manual for Hitachi 53sdx89ba click HERE!

Mar 12, 2008 | Panasonic PT-53TW53 53" Rear Projection...

1 Answer

Hitachi 53SDX89BA HD settings

Problem more than likely with the xbox, as the output stream of data from the game platform is not always consistent...accordianman

Dec 29, 2007 | Hitachi 50UX57B 50" Rear Projection...

2 Answers

Hitachi 53SDX89BA

I also have a Hitachi 53SDX89BA and I bought it with the same assumption as you: that it's HD ready. The specs in the manual states the following: "Full 1080i HDTV Capatable with Set-Top Box". I beleive this means that it does not include an HD tuner, but that it is capable of handling up to 1080i resolution. Normal (non-HD) resolution on this TV is 480i.

So here's my problem: Until recently, I wasn't using the HD settings on this TV because I don't have a set top box, nor do I subscribe to any HD content from my cable provider. However, I just purchased an XBox 360 along with an XBox 360 HD-DVD player (it's an XBox peripheral that works with the game console). The Xbox asks you to choose the resolution output (480i, 720i or 1080i) to match your TV's HD capabilities. When I select 1080i output and change my TV's settings to receive an HD signal, the picture quality is amazing. However, the video signal seems to get lost ocassionally (i.e. TV picture gets scrambled) but then it comes right back. This does not happen when I select a 480i output on the Xbox...but of course, the picture isn't as crisp and clear as a 1080i picture.

I don't know if this is a problem with the TV or with the Xbox. Has anybody else had this problem??

Dec 06, 2007 | Hitachi 50UX57B 50" Rear Projection...

Not finding what you are looking for?
Hitachi 53UDX10B 53" Rear Projection Television Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Hitachi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides