Question about Panasonic TH-50PX75U Plasma HDTV

1 Answer

Problems with TV volume intermittent dropout

I am having problems with my tv audio, but not when signal runs through stereo receiver. HDMI cable is connected to satellite.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: Problems with TV volume intermittent dropout

I fixed my problem by turning off the Bass Boost on the TV. Not sure if there is a problem with Bass Boost itself, but it sounds much better now.

Posted on May 14, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

What can be connected to te audio output jacks on the back of this set?

You didn't include make and model TV; so only generalized answers are possible.

Typical RCA phono jacks like those shown in the blue box of the stereo amplifier below:

25998201-ac5bgneb45fvu53muoueauti-3-0.jpg will accept cables to connect to other audio devices. The audio RCA jacks are color coded RED (right) and WHITE (left) for low level stereo signals. Some have YELLOW jacks for Standard Definition video, ORANGE jacks for AC3 Digital audio and newer amps have HDMI jacks.

Connect the TV's audio OUTPUT jacks and a stereo pair of unused audio INPUT jacks on the amplifier with cables that have ends that match each. Turn on the stereo & TV and select the input on the amplifier that matches the stereo pair of inputs you used to connect to the TV. Adjust the volume to hear the audio over your stereo system's speakers.

Use the HDMI or AC3 sources for superior audio - including 5.1 (or better) Dobly Digital when possible. Otherwise, a standard 2 channel stereo program will be heard.

I hope this helps & good luck!

Dec 08, 2015 | Flat Panel Televisions

2 Answers

How can I make a NEC Plasma Monitor that was given to me work like a TV that has AUDIO?

If it has no internal sound, then you obviously can't make it function like a TV aside from the picture right? It does have inputs whether HDMI or standard Cable wiring to see TV from a cable box?

You'd need to have RCA cables coming from the cable box (Audio out - white wire I'd figure) going into a stereo near the monitor that has a VIDEO button on it where the white RCA cable is plugged into the Audio In jack.

A stereo receiver or even old sort of stereo with a Video or Auxillary sort of jack with button to activate that jack will allow for surround sound from the stereo coming from the cable box in sync with the video of the TV.

Feb 08, 2015 | NEC PlasmaSync PX-42VP5A 42 in. HDTV-Ready...

1 Answer

TV audio output vastly different for satellite feed versus DVD feed. Why?

It is possible there are separate sound level functions for the DVD player, the tv and the satellite box, try the different remotes for each by unlocking the volume control on the satellite remote until you get them close or use the device specific remote volume controls. I would also try and use HDMI if available for the DVD instead of composite. If the volume controls are different it will show on the tv, might also go through all audio settings for each device. Some devices are pre-amped or send out strong sound signals while others are line level outputs designed to be amped by the output device, in this case your tv I believe. The HDMI vs stereo audio that goes with composite may be the cause or it could be in the settings of the device. Worst case is to remember to drop volume before you switch back so you don't ruin speakers.

Jan 25, 2015 | Flat Panel Televisions

1 Answer


Hi, sorry but Most LG's no longer have audio outputs. The easiest way to get it ,You need to take the audio output from the source i.e. "cable box output"..if you have of course...
However whether your TV has this output or not we need to make some tests..5 different connections possibilities provided below.
(not by can start with any of it ).Below ,there is a sample TV back panel picture as well
1) 2x RCA ports red / white is audio out ( L + R ) of TV to Stereo..
2) You can get also the audio digital output from the TV to a A/V receiver. the tv's optical audio out is stereo only mainly designed for freeview or tv audio to be output,
set the audio ouput on the TV menu to Dolby Digital, connect a digital optical out directly to the A/V receiver to receive audio signals.
3) since your TV has :2 x HDMI, SCART, AV, Component Video, VGA-sub, USB 2.0, connections,you may use the SCART plug to get Audio output for your TV .
TV's SCART connector which has 21 pins and "2x Audio Output " pins should be in it.
you need to buy an adapter called " RGB Scart Male to 3 RCA AV Female Adapter Converter" that can easily be found any electronic example as found eBay URL is below..
After you get this adapter,you need to carry the audio signal from SCART's RCA plugs to your Receiver with a 2x RCA (white/red ) cable.(if this does not work ,mfg should state somewhere in the your TV's "SCART socket IN only" ) if you properly connect IN/OUT plugs you will able to get the audio signal of the TV thru stereo..I recommend 2 $ value "RGB-Scart-Male-3-RCA-AV-Female-Adapter-Converter" with IN/OUT switch on it.
4) use HDMI connection of TV if you have HDMI input on your stereo of course...
5) if these are not an audio-out on one of these connectors , so you'll need to use the headphone socket if you want to plug it into a stereo. you need a cable 2x RCA to 3.5mm Headphone jack.
( This is the last ditch solution , since it mutes the whole sound.) ..
NOTE: if you connect this, pls be careful,your TV voice level will drive the stereo volume....

Hope this helps!..if more help requires Would you please let me know the result ?
Take care and please
Remember to rate/vote and give me 4 Thumbs Up for us
to continue f
or Helping out the Community :)


Jul 09, 2011 | Flat Panel Televisions

1 Answer

How do I connect a Sony KDL55EX620 HD TV to a stereo receiver. I am using the HDMI cable from a DirectTV receiver. How do I get the audio to my stereo?

the audio comes out of the Direct TV reciever, OR Audio OUT on the television. Some TVs that take the signal HDMI, do not put sound back out, and in that case, sound signal must come from the reciever box.

Each component, like DVD of Blu Ray will need to have a signal wired to the stereo unit.

Apr 27, 2011 | Sony KDL55EX500 55 in. HD-Ready TV

1 Answer

Westinghouse TV no stereo

Hi my name is Roety,
I can help you with your issue ,
Why don't you simply run the cable box and DVD stereo outputs direct to the receiver. Thats what most people do. TVs do not passthrough stereo signal very well do to DHCP compliance requirements .

If I have helped you with your issue please click accept.
If you have more questions you can still respond until this post expires,
I will reply asap

Nov 11, 2009 | Westinghouse TX-42F430S Television

1 Answer

Intermittent loss of audio single

Go into your Audio section of the Menu and make sure that SAP is turned OFF. Let me know how you did.

Apr 21, 2009 | LG 42PC1DA 42 in. Plasma HDTV

1 Answer

Volume Problems: Panasonic TH-42PZ700U

please could you send me tips of what the problem of my plasma keeping stuck pixiel panorama LCD Tv model 42LC68T

Mar 29, 2009 | Panasonic TH-42PZ700U 42 in. Plasma...

3 Answers

Sound problem with Sharp LC-32D4U

I got the sound on my LC32D6U fixed for free. Even though the TV is out of warranty, Sharp considers it under warranty for the sound problem. The number i 800-237-4277.

Mar 23, 2008 | Sharp Aquos LC-32GD4U 32 in. LCD HDTV

1 Answer

Volumne on Akai LCT3285TA

Often a signal might experience a super-quick "drop" in signal strength, and the display is automatically adjusting the now weaker audio signal to "mono" (temporary, as for best quality). But the dropout is usually so brief you will then see the "stronger" signal restored [full strength], and now the audio is "stereo".

It's like a "bump" or "disturbance" that occasionally affects the cable/satellite/OTA (antennae) signal being fed into the TV, and your display's attempts to compensate for the weaker signal [going to mono, then back to stereo once back to full strength].
Connecting it to your cable directly (bypassing the box) or an antenna would give you a true over-the-air signal, which would be proper MTS and would not give you any more pop ups.

Jan 05, 2008 | Akai LCT3285TA 32 in. LCD Television

Not finding what you are looking for?
Panasonic TH-50PX75U Plasma HDTV Logo

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Flat Panel Televisions Experts

The Knight
The Knight

Level 3 Expert

66685 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

charlie rodriguez
charlie rodriguez

Level 2 Expert

151 Answers

Are you a Panasonic Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides