Question about Motorola Mobility RAZR V3

1 Answer

Bought Dolce & Gabana gold faceplate, took apart, now cant get back together

Help, I bought the gold faceplate set, took apart the phone, now i cant get it back together

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 241 Answers
Re: Bought Dolce & Gabana gold faceplate, took apart, now...

You can send it to
we are cellphone repair specialists - cost is about $40 + shipping - and we can even give you the official D&G firmware too.

Posted on Jan 16, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

My sonyericsson k850i touch screen is not working

Sir, try reinstalling your phone. This will make the phone to be back to its original settings and maybe can bring the phone's touch screen capability back.

Jul 19, 2009 | Sony Ericsson W850i Cellular Phone

1 Answer

Nokia 6210 Nav new screen just flashing white

These models 5110,6110,6150,6210
Are very sensitive in display contact.
Sometimes if u just dropp the phone The screen can start to fade.
take the phone apart again and dlean all the gold-plated connectors on the screen and contact areas on the mainboard with a cotton stick soaked in
isoprophanol. Let it dry avoid fingering on the cleaned surfaces.
mount the screen carefully to the mainboard tighten the skrews from left to right to finally tighten the skrews carefully.
This should do it! Please vote!

Jun 06, 2009 | Nokia 6210 Cellular Phone

1 Answer

The speaker of my phone is not working at all,it mean i can hear you but you cannot hear me.

Hi my phone had similar prob with nobody able to hear me, the hole for the microphone is very small and can fill with dirt and fluff. To fix it I followed a dissasembly guide found on google and took the phone apart and removed the mic(be careful its very small) cleaned out the hole and fluff of the mic the put it back together and its works fine now. Sorry cant help with the not being able to hear other person. Regards steve

Jul 15, 2008 | Sony Ericsson W850i Cellular Phone

1 Answer

Sony Ericsson S500i

Dear KellAnne

Please find all the instructions at the following link in order to take apart the phone.

Many Regards,

Please rate this solution if you found it to be usefull! :) thanks.

Apr 08, 2008 | Cell Phones

3 Answers

Complete cover change

Go to my site and download the service manual for the N95. The link will be there for 1 week from today.

Mar 29, 2008 | Nokia N95 Cellular Phone

1 Answer

Limited service message on phone

your phone is blacklisted,or is having bad antena connection,if you know that it is not blacklited desmentle the phone and clean the gold turnished doted with a isoprophyl alcohol wait for the phone to dry put it together after drying it will work. advise by dogy.

Dec 30, 2007 | Samsung SGH-D600 Cellular Phone

1 Answer


Found this on Howard Forums. Sorry no photos.


Take off your battery, unscrew the screws on the back of the phone with a T6 screw driver.

Pry off the back plate,lift up circuit board gently(be mindful of flex cable) remove the flex cable from mail board by lifting brown part by the connector,

Unscrew then next 2 set of screws(be careful of flex cable!) remove the LCD board from the faceplate.

Now put the LCD Panel into the new faceplate. Find the new back slide and put your sliding rails on.(you may also put the slide magnets on from the old housing) carefully thread your flex cable through the opening.

Snap the Back slider on and then screw in the screws, then take the keypad housing and screw it into the slide rails.

Reconnect the flex cable by putting the brown hatch up(gently with finger nail) gently feeding the cable into the connector until the white line is about to the end of the connector.

Then put the brown thing down and apply little pressure.

Put the mail circuit board back into the phone with the headset jack going in first.

Then snap it back into place.

Transfer your speaker over the the new back housing with the prongs facing up.

Then screw on the back housing.

Replace battery and your DONE!!!

Best of Luck.

Please RATE my solution BELOW.

Nov 25, 2007 | Kyocera Slider Remix KX5 / Sonic Cellular...

1 Answer


I had the same problem and I was lookin on a forum/blog on how to do this,but not many helped.I'm about to attempt to change my faceplate and I noticed when you take the battery cover off,there are 4 screws under the cover,and one near the antenna.You probably have to take apart the back part of the phone to get to the screws that are attatched to the sliding part of the phone.Its probably a little risky and tricky,but Im guessing thats how you get to the 2 hidden screws.


Nov 20, 2007 | Cell Phones

1 Answer

Putting on faceplate for samsung t319

hi you best bet is go to a repair mobile shop if are in doubt to try this .
you'll need a small Philips head screwdriver to complete the installation. To take off original faceplate, remove 2 screws located below the inside display (screws are hidden under stickers). Next, gently pry off the faceplate along the edges between faceplate and phone with a Faceplate Removal Pry Tool. When re-attaching screws, do not over-tighten screws

Aug 23, 2007 | Nokia 6288 Cellular Phone

Not finding what you are looking for?
Motorola Mobility RAZR V3 Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorola Mobility Cell Phones Experts

D. E. Hev

Level 3 Expert

1059 Answers

Chris Hunt

Level 3 Expert

1342 Answers

Lawrence Oravetz

Level 3 Expert

7159 Answers

Are you a Motorola Mobility Cell Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides