Question about Panasonic (KX-TG1032S) Phone

3 Answers

Voices breaks up when phone is over 25 feet from base unit.

Panasonic KX-TG1032S - Base phone and 2 extensions in home. Phone at base unit in bedroom works fine. One extension is in room directly below the base unit, putting it about 12 feet from the base. When using this one, the reception is good for the person using the phone. However, the person on the other end of the line cannot hear you because your voice keeps breaking up. The only solution the instructions offer is to tell you to move closer to the base unit, which is not possible in this situation. I solved this problem by plugging my wired phone back in. The other is in the kitchen on the same floor as the base unit in the bedroom, but at the other end of the house, about 50 feet away. The same problem occurs when using this phone, until you walk to about 25 feet from the base unit and then the problem clears up. What is wrong here?

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 64 Answers
Re: Voices breaks up when phone is over 25 feet from base...

Sounds like you have some interference within your home. Causes of this are wireless interenet, microwaves, radios, stereos, baby monitors etc. Pretty much anything that uses a wireless connection or antenna. These sorces of interference are intermittent depending on if they are being used, where they are located, how much power they use and their type of signal/channel. Try moving the base(s) around your home to get a better, clearer reception If your phone is equipped with a channel/frequency selector try changing or adjusting it and see if that helps.

Posted on Jan 17, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,427 Answers
Re: Voices breaks up when phone is over 25 feet from base...

Hey sorry about that expert he/she is possibly missing a few brain cells or a brain for that matter.. But the idea of foil to boost recepton inst a bad one at all,,

Ok firstly there must be a ranger specified in the distance the wireless phones dhould work from, If its in the specified range but dont work there are a few possible causes..

1.) Interference,, does it do this all the time , or just when certin things are in use, like your blender, microwave, refrigators.. Basicall all eletronic devices emmit electromagnet waves which wil cause interference.. If you got it close to the fridge or where so ever close by or on one i suggest you try it somewhere else..

2.)Defective Product.. IF it isnt interference, and you got warrenty the first thing i recommend is taking this item back.. If you havent any warrenty you still have a few options..
You can take it in to a service tech to let him try to figure out whats wrong with it.. (VERY UNLIKELY HE CAN FIX THIS SINCE THESE ITEMS ARE CONSIDERED DISPOISABE AND THEREFORE ARE MADE WITH MICRO CIRCUITS).. Or you can ask him if he can add transistors to help boot the signal, most often this inst possible on certin items..

3.) Sometimes A low or defective battery also can cause this problem, you might want to have a look at this as well..

BUT as i will strongly recommend to you, Try looking for a source of interference and if there isnt any then have a look at the batterys.. If not it will deffenately be most fesible to purchase a new one..

If there are any changes or anything else you would like to ask please by all means post it here and i shall reply as soon as possible..

Posted on Jan 17, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 871 Answers
Re: Voices breaks up when phone is over 25 feet from base...

Use foil. put it on your antenna.

haha. this might work.

Posted on Jan 16, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

My panasonic home phone only rings once, it used to ring normally and would also say what number is calling. please help.

We recommend you unplug the Panasonic base unit and make a test call from another number. If the line disconnects after 1 ring then you have either a telephone line problem or another device connected to the telephone line is the problem.

Mar 03, 2014 | Panasonic (KX-TG1032S) Phone

1 Answer

110v base plugged into 220v

Hi Allen,

Yes you can fix.
please go to repair personal with power adapter or buy same type one or by alternative power adapter but output must be same as the original and 220v as in .i think buying new one is a good idea.


Jan 09, 2014 | Panasonic KX-TG9341T Cordless Phone

1 Answer

I have KX-T7730X corded, how can I add extension to our PBX.

It requires a "home run" back to a control unit and an open port. They're wired with 2 pairs, the same as the other phones in your system.

As an alternative, you can plug the base cord directly into the control box.


Nov 29, 2010 | Panasonic KX-T7730 Corded Phone

1 Answer

The (2) handsets are searching for the base

Problem solved; i applied the registration procedure as described in the manufacturer instruction manual page 34 Thanks for your help

Dec 05, 2009 | Panasonic (KX-TG1032S) Phone

1 Answer

I have a panasonic cordless phone, model kx-tga820. for some reason both handsets now say that it is busy when i push the talk button. Our other phones are ok. Why?


If you get busy tone in your Panasonic KX-TGA820 cordless phone, it may be due to any one of the following reasons:

1)The called handset is in use.

2)The handset you are calling is too far from the base unit.
Check whether the base unit is not so far from the handset

3)There is no handset registered to the base unit matching the extension number you entered.
Try to re-register the handset to the base unit again, To know details regarding registering and re-registering, please refer page 38 of the manual, which you can download from the link given below

4)Other units are in use and the system is busy. Try again later.
Try to check whether the other units are not using your base unit

You can download manual for your phone from the following link for reference

Please rate this solution

Nov 10, 2009 | Panasonic Phones

1 Answer


Hi! This may cure your problem!
Re-registering the handset
If “No link to base. Move closer
to base, try again.
” is displayed
even when the handset is near the base
unit, you may need to re-register the
handset to the base unit.
LMake sure the base unit is not being
LHave the handset and base unit near
each other when re-registering the
LKX-TG5422 and KX-TG5423 only:
Confirm the extension number of the
handset which has lost its link to the
base by placing the handset on the base
unit or charger.
If you accidentally assign another
handset’s extension number to it, the
other extension will stop functioning.
1 Handset:
Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Registration” by pressing
{V} or {^}, then press {>}.
4 KX-TG5421 base unit:
Press and hold {HANDSET
} until the CHARGE
indicator flashes.
KX-TG5422 base unit:
Press and hold the handset locator
button that corresponds to the handset
you want to re-register ({HANDSET
1} or {HANDSET
2}) until the CHARGE
indicator flashes.

Below is a link that will take you to the instruction manual for your phone.

Hope this helps! Hal

Feb 27, 2009 | Panasonic KX-TG5422M Cordless Phone

1 Answer

Semi Dead Panasonic KX-TGA100N with ''C533'' displayed.

Panasonic KX-TG1050N Cordless Phone. Base handset (No. 1, KX-TGA100N) does not work, no keypad response or dial tone. Green indicator message light ON (should only work with the TG1000N base unit) all the time till battery runs down. Display shows message ?C533?. Can still send and receive calls on extension phones 2 and 3.

Nov 11, 2008 | Panasonic KX TG1000N Cordless Phone

2 Answers

Adding handset to Panasonic KX-TGA542M phone. ? how to ?

I ordered a new kx-tg560m handset for my kx-tg5632 base unit, but the enclosed instructions for registering it with the base unit were wrong. Fortunately, I found the old quick setup guide in my files.

If you do not have the same base unit and handset, go to the URL:

1. On the handset, press [MENU], then press [0][0]. The handset displays "Refer to manual to prepare base. Then press OK->"
2. On the base unit, press [SELECT] until the desired extension number [H1, H2, H3, or H4] is displayed on the base unit, then press and hold [CALL] until the CHARGE indicator flashes.
3. On the handset, press the [OK] softkey.

When the handset is off and sitting in the charger, the handset's extension is displayed in the upper right corner.

Oct 27, 2008 | Panasonic KX-TG5422M Cordless Phone

Not finding what you are looking for?
Panasonic (KX-TG1032S) Phone Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Phones Experts


Level 3 Expert

93802 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers


Level 2 Expert

82 Answers

Are you a Panasonic Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides