Question about Standard (CRT) Televisions

1 Answer

Toshiba television why do i have a black screen and a line going through it i have a toshiba color model # ce30e50 please help need to know if i can fix myself to save money

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,267 Answers
Re: toshiba television

It looks like your vertical IC is defective on your TV set.
I would suggest to use a magnifier glass and check for cold solder joints around high power resistors.

Posted on Jan 15, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Toshiba 27A40 has single colored line across enter

Vertical output has cracked soldering. Around $150 to fix.

May 01, 2010 | Toshiba 32A33 32" TV

1 Answer

I can't seem to get accurate color, and I've tried a bunch of different custom color and contrast options... what should I do? (There is a sort of sepia tint to the screen)

Try adjusting the Screen voltage. Easiest method I know of: remove rear cover, locate the FBT (has a large red wire running from it that attaches to the back of the tube). You will see 2 or 3 adjustment knobs on it the should be labeled if you look close (screen is normally on the bottom). Turn the TV to a black screen (often an empty input works well). Slowly adjust the screen voltage knob (small screwdriver required) Clockwise, until you see some beam trace lines on the screen. Now, begin slowly turning it Counter Clockwise until the lines are gone and the screen just turns black again. Press the menu button and use the on screen menu and the top knob(s) on the FBT to fine tune the focus. Leave the cover off for the moment and see if your color is better. Repeat the adjustment if needed. If this does not help your situation, you may have something else going on... let me know.

Mar 15, 2010 | Samsung Ultra SlimFit 20" Digital TV

1 Answer

Toshiba TV Red Color turns black and regains after a long time

If this is a crt type, it could be a loose connection. Check its RGB board usually located at the backend of the crt tube. Dust, cobweb, carbon built up might be the one causing it.

Apr 12, 2009 | Toshiba 36AF41 36" TV

1 Answer

No color picture on Toshiba CF36G40

You need to go to the menu screen where the contrass, color etc are located. Scroll each option and one of them will add the color, one of them is probably at 0 so you need to ensure that it's added

Feb 15, 2009 | Toshiba CF36G40 36" TV

1 Answer

My Siny Trinitron G21M1 is producing horizontal lines across the screen

I hope your TV model is Sony KV-G21M1 and you see color bars as horizontal lines across the screen.
Let me now are you tech guy or know how to repair TV to guide you further.

Oct 26, 2008 | Sony Standard (CRT) Televisions

1 Answer

Black screen with colorful line going horizontally through the middle of the screen

Problem in the vertical circuitry.
If you have the know-how, check for "cold-solder" joints around vertical i.c.
Also, bad electrolytic caps.
Voltages ok?
Resistor values ok?
Replace I.C.

Don't tell me the yoke wires were off or gnawed thru by a roach!

Aug 07, 2008 | Toshiba 32A33 32" TV

1 Answer

White horizontal line down middle of TV screen

caution whenever you see horizontal line please reduce brightness of your tv for safety of crt. your problem in vertical section only mostly due to loose contact in connector,print or loose components.

Sep 20, 2007 | Mitsubishi CS-35505 35" TV

2 Answers

Color line across the center of a black screen

Hi. this is caused by dry solder joints on the frame o/p IC. Resolder all legs of frame chip. Should sort that out.

Sep 06, 2007 | Toshiba 32A60 32" TV

1 Answer

55'' t.v. blurry screen on right side with green line going down

SWounds like the convergence is bad in this set. If there are color outlines or part of the picture looks like it is in 3-D, you will have to have someone change the convergence ICs. Good Luck

Jun 09, 2007 | Toshiba 36A40 36" TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66352 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides