Wm2077cw i started a load paused the machine put one more sheet in then re started and got the LE warning.I pulled the extra article out tried restarting but came up with same error.Is there too much wet weight in the washer?How can I spin out what is in the washer now?

Hi,
No all you have to do is watch how much and what kind of soap you put in that washer...

http://www.fixya.com/support/r4348161-lg_washing_machine_le_error_code_or

heatman101

A majority of the time when the LE code appears.. the Hall sensor in the motor is bad. Replacing it. Part # 6501KW2002A from MCM electronics... can help. Good luck.

mach not work cord com le or pe

to help clean the unit, do a large load of whites, extra bleach, extra-super-heavy-duty wash, hot wash and hot rinse. many small loads sometimes cause the unit to "smell up"

The LE code represent a failed or locked motor. the replacement of the electrical motor will be needed in this situation.

Hi,

error LE Overload in motor.unplug for 1 hour plug back in. motors going bad or over loaded with stuff.

If not, you need to call tech.

Thanks.

i have found that the micro switch burns out on them and needs to be replaced. remove rear screws remove top cover , remove shield the unclip cables and front panel

Use a multi meter to test micro swicth on circuit board replace if faultsy

LE is a locked motor error. If this happens often then 95% of the time this is just a bad hall sensor (motor position sensor). A technician should be able to ohm out the hall sensor to make sure. The part is relatively inexpensive and easy to replace.

This can also happen if the motor is overheating slightly from being overfilled (too many clothes) or if you do one load after the other and do not allow at least 10-15 minutes between loads for the motor to cool down. In this case the LE error will only happen occasionally.

Hope this helps, please rate my solution.

un plug your machine for an hour if you can open the door open it and then put the machine plug back in with the door open keep it open till the machine comes on then put the program to what you want and then shut the door it then should be ok its called a reset try it hope this solves your problem

Suggestion: Your wash could be overloaded; put in clothes within machine's capacity. What is written in your manual's max clothes capacity. If your heater is on; switch off machine and wall plug. Reset the machine with the heater on minimum & resume your normal cycle.