Question about Audiovox FPE3000 30 in. HD-Ready LCD Television

3 Answers

Plv16081 same problem

Powers on for 1 sec and then goes off. any answers?

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: plv16081 same problem

I have a repair manual, and can send it via email.
Contact me if you still need it.

Posted on Apr 08, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: plv16081 same problem
  • Level 1:

    An expert who has achieved level 1.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Contributor
  • 4 Answers
Re: plv16081 same problem

I would say backlight inverter board or power supply. When it goes off, shine a light at the lcd and check if you can still see the image. If you can then it's the backlight, if you can't then it's something else like the power supply.

Info about other models with similar problems can be found here:

Mike (

Posted on Jan 29, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Picture goes on for 30 sec. then off for 45 sec.,power/standby lite then blinks.can this be fixed or thrown out.SONY KDF-E50A10

Search Results

    KDF-E50A10 Sony TV - turns off and on - on its own - Sony's ...
    Sep 12, 2014 - Our TV turns off and on without warning on its own. The standby lights starts to blink and the picture and sound go out, then 30 seconds to a ...

    Sony KDF-E60A20 problems - High Def Forum - Your High Definition ... > ... > Rear-Projection TVs

    Jan 19, 2009 - 14 posts - ‎11 authors
    I recently got a 60 inch Sony KDF-E60A20 from a friend for around. ... runs for about 1 minutes then goes black(no picture no sounds), then the picture and sound come right back on for another minutes then off for 30 seconds.

Jan 18, 2016 | Flat Panel Televisions

2 Answers

My 15 month Celcus LCD423D913FHD tv will not turn on. The standby light is lit and will flicker but will not power up the tv. What is the likely problem?

Fault with its main board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. . In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Oct 20, 2014 | Flat Panel Televisions

2 Answers

Dynex tv powers on and than goes off

I would start with a look at the power supply for puffed up caps.

Dec 13, 2012 | Dynex Flat Panel Televisions

1 Answer


try to replace the (-) volume button it is defective so the volume will auto down..

after you replace that 100% works fine..

Apr 27, 2012 | Audiovox PLV16081 8 in. LCD TV

1 Answer

Picture is schinking in on both sides

the picture is narrowed on the sides when you are not on a high def program.
commercials will often be standard def even on a high def channel.

check you cable or satelite box setting to "stretch" analog programming automatically.

Apr 12, 2011 | Audiovox PLV16081 8 in. LCD TV

1 Answer


These Tv's (lower end chinese sets) have been comming in in record number, most have power supply issues. Look over the power board carefully. Look for expansion on the capacitors. And spots that may have run warmmer than normal.

Jul 11, 2009 | Hisense LCD1504 15 in. Television

1 Answer

Digital signals

if it was manufactured before 2007/8 then probably not- good way to check is to run an auto scan in the set up mode- if the tuner is digital it will find the 7-1 7-2 etc digital channels that have been placed in between the analog stations

Apr 12, 2009 | Audiovox FPE3000 30 in. HD-Ready LCD...

3 Answers

Screen only stays on for 1 sec

Assuming you changed all the caps and did it correctly.
IF you get flickering, It could be a transistor on the inverter board.
OR !!! and probably more likely,
It could be one of the bulbs in the lcd itself is failing. It only takes one bad bulb to stop an inverter from firing up !! You can check them one at a time if you have another working monitor.
If you do unplug a good bulb from the good monitor and try each of the questionable ones, one at a time.
Doesn't have to be a gateway monitor to test it, just needs the same backlight plug.
ebays bammbammfran

Jun 05, 2008 | Gateway FPD2185W 21 in. LCD Television

Not finding what you are looking for?
Audiovox FPE3000 30 in. HD-Ready LCD Television Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audiovox Flat Panel Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

olayoju victor

Level 2 Expert

191 Answers

Dave Naylor
Dave Naylor

Level 3 Expert

834 Answers

Are you an Audiovox Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides