Error code c-d369

NVRAM failure, need to have tech come out and re-flash the firmware of the machine. and check the NVRAM memory board. This firmware is only available thru a secure Konica Minolta Web site.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Error code reset:turn OFF the copier ,press and hold the Utility key to right hand,to left hand turn ON the copier,wait appaire on the display Trouble reset,touch the screen and turn OFF the copier.Wait 2 minute and turn ON.

This is a common error code for Ricoh copiers, Savin and Gestetner copiers that need service. Recently Ricoh has purchased Lanier and now is naming all their new machines Lanier instead of Gestetner, Savin and Ricoh. However, the copier service error codes have remained he same.
When you get this copier printer service code it means the fuser or fixing assembly (same part) has thermistor problem. The copier fuser's thermistors help regulate the temperature of the fuser assembly. The fuser assembly on all copiers including Canon, Kyocera, Ricoh, Sharp and other brands is the part that melts the toner onto the page.
Getting back to the repairing the copier on Ricoh, Savin, Lanier and Gestetner models that have the fuser or fixing code error. The majority of the time the fusers' thermistors (Middle and read) need to be replaced. Just cleaning them will not solve the copier repair service code.
It is usually, depending upon the machine, its a 1 to 2 hour copier repair job because the copier repair service technician will need to dissemble the fuser, insert the two new thermistors, re-assemble, reset the error code and test the copier machine repair. Also, ask the copier technicians to to do a copier cleaning maintenance while on site.

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

goto service mode by pressing 10871087. then press 163 then start 4 times.the machine will restart and wola

What is the malfuction code showing on the display? This code will be a letter followed by 4 numbers. Such as C3542. Reply back with the code so we can assist you further.

You will have to call a Copystar or Kyocera technician to reset your fuser memory.

I don't have that error code specifically but any error code that starts with an H has to do with the fuser section of the machine. It could be the thermistor, rollers, or the heat lamps.

It should be looked at by a Sharp technician to determine the correct problem.

1. Touch the following code on the trouble code display screen.
Stop → 0 → 7 → 1 → 3 → 9
2. [*] will be displayed on the trouble code screen.
3. Touch [*].
4. The screen will be shifted to the data restoration screen to perform data restoration.
NOTE
• When the restoration is performed in a short time, data restoration screen may not
be displayed.
5. Check the message which indicates that the data restoration was successfully conducted.
Turn Main power OFF, and wait for ten seconds or more to turn it back ON.

Try this please and tell your tech support service to change job....
DaSoP from Greece!

I have a toshiba estudio35 copier I CANAT INSTALL IP\TCP IN MY MACHIN

You need a service guy to stop by. Resetting the machine is a temporary solution only. Service will be able to print reports and see where the issue lies if it goes beyond just fixing a part.