Blinking Green Light of Death on Mits WD 52525

change tv mainboard

I have a Mits rear proj screen ws-55613 replced the 4 caps on the DM and still have th fast blinking green LED any Ideas?

Did you get yours resolved? I had the same thing. The repair guys called it the "flashing light of death". It indicated the TV is dead.

Defective capacitors on the DM leaving it plugged in the caps still work sice they'r e charged, But unpluggung allows them to discharge then they wont charge up again since they're defective so you get the blinking light. You can get the V26 DM repair kit from www.tvrepairworld.com which has the replacement capacitors and the CD with repair instructions.

your problem is in the dm module
there are caps in the supplys on this module that vent and cause the blink of death symptoms

if you have the tools and feel capable you can get a kit at www.
tv world .com

Hi the cartridge's work is to hold the lamp in place it will not go faulty or melt or will prevent tv from lighting up.Did you close the door cover on the back properly.Did you reset the lamp timer? Do it by unplugging tv wait 5 min and plug it back again.Pay attention to clicking sounds or like wanting to turn on it could be a bad ballast and that's the board that powers the lamp.Hopefully you dont have "The green light of death" Issue. It tells all about it here http://www.highdefforum.com/rear-projection-tvs/58189-blinking-green-light-death-frequent-prob-w-mitsubishi-rear-proj-widescreens.html Good luck and God bless you!

There are "kits" available on the internet. If you bought one of these...it should have come with detailed instructions for replacement purposes. If not...contact the SOURCE of the parts for further installation instructions

i have seen a couples mitsubishi and i all ready talked with a tech suport from mitsubishi but they said change the capacitors in the shop were i work we do the same but the tv still doing the same then we send the dm module to them and they fixed we asked whats the real problem and they said the capacitos the best i think is send the module to them

the dlp will most likely need a qualified mits repair center to take over for you. repairing that set is pretty involved. and the parts you would need are not available to the public.
on your 48" CRT projection check the DM module for 4 vented 1000mf 16v capacitors. replacement should get you tv working great

hold the menu bottun for 10 seconds
after press power

see if that works