I am trying to hook up a netgear wirelees router having when get to the screen with user name admin and ask for a password on back of the router that the password is password? it keeps kicking me out of the setup.

All netgear routers have the same default user names and passwords, so unless you have changed it you should still be able to use the default one set by the manufacture.
IP address: 192.168.1.1
User name: admin
password: password
This is the default info for netgear.
If you are looking for your wireless password it will be found in wireless settings of the router on the admin page for your router.

Hi,
Default settings will be as mentioned below....
IP address: //192.168.1.1
Username: admin
Passsword: password

Thanks,
Satheesh

user name is admin password is password

Hello
First unplug router.Then hold reset button in for 30 seconds,button is usually in the back may need a pen tip or paper clip to hold it in.

Then plug back in.Try logging on using admin as username and password as password.

Which password do you mean? The wifi passowrd or the admin password?
The admin password is likely to be password (if it hasn't been changed) but the Wifi password you will only be able to see if you can access the router.
Easiest way is to use an ethernet cable between the router and the computer. Open up the netgear admin page (admin & password), then on the left hand side click on Set-up and then select wireless settings. Your wifi password will either be written on the next page or you will see four boxes of numbers with a blue spot against one of them. That one is your passowrd.

should be admin password should be either blank or password

If you need further help, reach me via phone at https://www.6ya.com/expert/david_eb7ea98642566cc6

simple by default is 192.168.0.1 just type in internet explorer or fire fox in the address bar 192.168.0.1 they ask the user name and password

user name : admin
password : password or blank or admin or 1234

try this combination you get it this way got the configuration page then configure it


if you want the full configuartion then i send you link download the pdf file for configuration then try it ok there is two link try it.


1.http://www.netgear.com/pdf_docs/WGR614v6...

2. http://www.netgear.com/products/details

Try a hard reset (small button on the back of the router, usually recessed and accessably using a paperclip to push it in)

This will restore the router to factory settings. The password and user name will revert back to the factory ones which for netgear is

User Name = admin
Password = password

Then once your into the router settings you can set the username and password to something you want.

Hope this helps

Hello
you can find it in your manual.
you can also look here
http://www.cirt.net/passwords?vendor=Netgear
so try with
username: admin
password: password

I do not know how to find out the password if they are not the default for Netgear, however you can try to reset the router settings to defaults. Use a paper clip, and push in a small button between where you plug in the power and Ethernet cables(while the router is on). After this the user name and password should be back to default, which are user name: "admin", password: "password" without the quotes.