Question about Frigidaire FRS-26DR7D Side by Side Refrigerator

4 Answers

Ice crusher has stopped crushing

I can get ice cubes but my ice crusher has stopped working.

i can toggle from cubes to crush and vice versa and the lights work but i do not get any crused ice.

what can i do to fix it?

Posted by on

  • 5 more comments 
  • sakkiy Jan 13, 2008

    I have the same problem. I am looking for a replacement part,

  • JustinR Mar 22, 2008

    Reverse problem: Crushed ice works when button selected but crushed ice also comes out when CUBE button is selected, both lights work as well.


  • lesnil May 03, 2008

    Ice maker dispenses ice cubes but when I select crushed ice, ice cubes are still dispensed but not crushed. No repair effort has been made.

  • Anonymous May 07, 2008

    Ice maker stopped crushing ice.

  • pete shenkle Dec 07, 2008

    I have a amana sise by side refrig. my ice crusher tries to chrush ice but seems to get stuck. are the blades dull?

  • magnum1b Dec 29, 2008

    My ice crusher (GE Model GSS25JFMCCC)stopped working when a plastic part in the ice bin broke. I know how to change that, but I would also like to pull the control panel so as to clean the damper door on the dispenser and am at loss as to how to get that section apart. Any help would be appreciated.

  • Anonymous Mar 01, 2009

    GE side by side Profile TPS24PPBABS. Ice dispenser works in cube mode but not in crushed mode. The light comes on when I push the button but the auger doesn't turn. I checked the solenoid, it works fine and the bar from the ice dispense is correctly positioned within the acutator. In the crush mode the motor doesn't even hum, so it's not jammed or anything. Any suggestions?



4 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has written 7 tips or uploaded 3 video tips

  • Expert
  • 93 Answers

There is a little bar that is on the ice bucket. That bar has to go into the middle of the plastic square that is on the back wall of the freezer. Try Pulling out the ice bucket, get a hair dryer and run the hair dryer on the back wall of the freezer right above the hole where that little bar goes. After you run the hair dryer for about 10 minutes or so put your finger in the hole and pull down on the plastic square. Make sure when you put the ice bucket back in the freezer, the bar goes inside the square hole, not under it, not over it. In it. If that doesn't fix the problem you probably just need a new solenoid. Part number 5304404333

Let me know how you make out. Good Luck


Posted on May 16, 2008

  • hafcanadian A
    hafcanadian A Sep 23, 2013

    I have the same problem, but have noticed that tweaking the spring on the back of the rod affects whether the gate opens or closes into the crush position. I can't quite figure out exactly what position the spring has to be in to consistently work. Is there a trick to it?


  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Perfect solution! Thanks Bill!

Posted on Jun 29, 2008


I followed Bill´s instruccion and problem was solved.
Thanks bill

Posted on May 23, 2008

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

My ice makers little plastic door broke so i got a new crusher assembly. Now the ice maker in the crush position crushed some ice but lets more full cubes through than crushed. any ideas?

Posted on Mar 15, 2013

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Getting shaved ice instead of cubes

Several possibilities, but check first for cubes that are too small (means too little water is coming in during ice maker fill) and those cubes fracture into smaller bits when they are dispensed.

Another possibility is the cube/crushed plate inside the dispenser is stuck. This is a curved plastic piece that lies next to the crusher blades inside the dispenser head of the ice storage bin. For cubes this place must be retracted (swing away from) the crushed fingers to allow the cubes to pass without being broken up.

Oct 30, 2016 | Refrigerators

1 Answer

Why is my icemaker not chopping/Crushing Ice

If there are blades involved then they might be bent and/or need sharpening.

Jun 01, 2015 | Refrigerators

1 Answer

Ice crusher stuck on crush

your ice solenoid is frozen. It is located behind the ice bucket next to the auger motor. It will need to be removed, unfrozen, and squirt a little wd40 to prevent it from happening again

Mar 19, 2014 | Frigidaire FRS26H5AS Side by Side...

1 Answer

Ge gss fridge,ice dispenser problem.

You have a solenoid switch which switches the dispenser back and forth from crushed to cube. The crush position is without the solenoid energized. It could be stuck or not working or the parts connecting it could be disconnected or broken. You will have to observe to see if any parts are moving and if any noise is coming from the solenoid

Your solenoid is part 45 and the linkage to the crusher is 46. The crusher is 41 on this diagram and parts list.

Feb 28, 2010 | Frigidaire FRS3R5EMB Side by Side...

1 Answer

Ice crusher don't work

Hi, It sounds like the selonoid that shifts the auger is not working. This part is located behind the panel that the bucket pushes against. The little wire arm on the bucket goes into this. Sometimes they just get froze up from the moister. If you remove the panel/section the selonoid is in, you can see if the part has went bad.
I hope this helps you. Please let me know If I can assist you further.


May 23, 2009 | Maytag MSD2650H Side by Side Refrigerator

1 Answer

Ice maker only makes crushed ice, no cubes

The button which selects cubes versus crushed controls a solenoid which engages/disengages the crusher. If the mechanisms which crush and push the ice from the chute are all clean, free of ice, etc., then the solenoid is not working. It either has loose/dirty connections or the solelnoid is bad.

May 05, 2009 | GE GSS20IEPWW / GSS20IEPCC Side by Side...

1 Answer

Crushed ice only.No cubes.

Pull the ice bin out about 4 inches and re-insert it in the slot in the rear to reset the crusher arm.

Mar 11, 2009 | Whirlpool GD2SHGX Refrigerator

1 Answer

Ice crusher has stopped crushing

Replace the switch behind the front panel on the freezer.

Mar 01, 2009 | GE Profile 26.6 cu. ft. Side-by-Side...

2 Answers

Ice dispensor only dispensing crushed ice - not cubed

Make sure that your ice tray is properly instaled. There is a rod that must go into a hole. When you select ice cubes rather than crushed ice a solenoid raises which moves that rod. It then opens a flap so the cubes can bypass the crusher. Either your rod is not in the hole correctly or the solenoid has gone bad. The rod that I am speaking of runs along the underside of the ice tray. It has a spring on the rear end that holds the bypass flpa closed.

Dec 02, 2008 | GE GSH22JFT Side by Side Refrigerator

1 Answer

The crusher function on ice making part of my Maytag Zigzag fridge freezer is not working. I have ice cubes but no crushed ice

pull the bucket and check the solenoid on the back wall this is what shifts the bucket to crushed and cubed

Jul 31, 2008 | Maytag Refrigerators

Not finding what you are looking for?
Frigidaire FRS-26DR7D Side by Side Refrigerator Logo

4,331 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Refrigerators Experts

Charles T Nevin
Charles T Nevin

Level 3 Expert

4070 Answers

John Tripp
John Tripp

Level 3 Expert

4655 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Are you a Frigidaire Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides