Question about Haier HLT41E Top Load Washer

2 Answers

The Dryer is not rotating

The dryer of my washing machine is not rotating.?The dryer of my washing machine is not rotating. I opened the dryer cabinet and make the supply on, I heared the sound of motor that it try to rotate, but it was unable to rotate the dryer tyb. I disconnect the tub and checked the motor rotation, it was free and not jammed at all. I again connect the supply, again motor sounds, but it did not rotate. Please guide me what next I have to do?
Thanks

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 833 Answers

Asad,

The other comment may be correct but I am not sure that you do not have a broken belt. If the motor is running...not trying to start and clicking off...the problem is the belt. The old one may be jamming the drum up.

Posted on Jan 14, 2008

Ad

Asad, if you are hearing the motor trying to start I would start with the motor capacitor. Looks like this model has a wash and spin side. Each side has a capacitor for the motor. The manual is not too informative but it looks like there is a switch that has to be made too. But if you are hearing the motor humm, I would start with that motor capacitor

Posted on Jan 14, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Maytag Neptune dryer doesn't stop unless I open the dryer door.


You will be needing to replace the timer assembly, which is the part that has all the wires attached and is found inside the top of the machine. It is what the dial is fastened to.
Be blessed.

Jan 08, 2014 | Maytag Neptune MDG5500AW Gas Dryer

2 Answers

Washer makes a buzzing noise when it tries to spin


Hello. Loud noises coming from a Washing Machines are most often caused by looseobjects inside the unit or by a broken dryer belt. The Washing Machines beltallows the dryer's motor to run smoothly. Continuous wear and dry conditionsmay cause the belt to dry out, eventually Washing Machines cracking and thensnapping. This will cause a loud noise within the unit. Repair and fix thedryer belt of a Washing Machines to get rid of loud noises. Instructions And Things You'll Needed to solve the problem.

Screwdriver ,Replacement Washing Machines belt 1 Stop the Washing Machines and look inside the dryer's drum for any looseobjects such as coins, pens or anything else that may have been in a pocket ofclothing. Remove the object and restart the dyer to determine if the noise hasstopped.
2 Unplug the Washing Machines from the wall outlet to disconnect all power tothe unit. 3 Remove the lint trap from the lint compartment on the top of the dryer. 4 Remove the screws that hold the top panel in place. Pull the panel off toaccess the
dryer belt.
5 Tilt the dryer forward and lift the dryer drum to remove the belt. Check theWashing Machines belt. A belt that is worn, cracked, split or broken will causeloud noises. 6 Slide the old belt off of the drum and pull it out to remove it. Take noteon how it is positioned over the drum.
7 Install the new belt. Lean the front panel away from the Washing Machines andslip the new belt over the drum. Locate the position of the old belt and slipthe new belt following the old belt's position ensuring the grooved side of thebelt faces down. Push the idler pulley towards the motor to allow you to slipand loop the belt around the motor pulley.

8 Place the top panel on the Washing Machines and screw it in place.

9 Open the Washing Machines door and use your hand to rotate the drumcounterclockwise a few turns to ensure the belt is secured.

10 Plug the Washing Machines into the wall unit and begin use . Thanks.

Sep 13, 2011 | GE Energy Star WCVH6260F Front Load Washer

1 Answer

Hi i have a speedqueen awm373w-3062 have noise on


Hello.

Loud noises coming from a Washing Machines are most often caused by loose objects inside the unit or by a broken dryer belt. The Washing Machines belt allows the dryer's motor to run smoothly. Continuous wear and dry conditions may cause the belt to dry out, eventually Washing Machines cracking and then snapping. This will cause a loud noise within the unit. Repair and fix the dryer belt of a Washing Machines to get rid of loud noises.

Instructions And Things You'll Needed to solve the problem.

Screwdriver ,Replacement Washing Machines belt

1 Stop the Washing Machines and look inside the dryer's drum for any loose objects such as coins, pens or anything else that may have been in a pocket of clothing. Remove the object and restart the dyer to determine if the noise has stopped.
2 Unplug the Washing Machines from the wall outlet to disconnect all power to the unit.

3 Remove the lint trap from the lint compartment on the top of the dryer.

4 Remove the screws that hold the top panel in place. Pull the panel off to access the
dryer belt.
5 Tilt the dryer forward and lift the dryer drum to remove the belt. Check the Washing Machines belt. A belt that is worn, cracked, split or broken will cause loud noises.

6 Slide the old belt off of the drum and pull it out to remove it. Take note on how it is positioned over the drum.
7 Install the new belt. Lean the front panel away from the Washing Machines and slip the new belt over the drum. Locate the position of the old belt and slip the new belt following the old belt's position ensuring the grooved side of the belt faces down. Push the idler pulley towards the motor to allow you to slip and loop the belt around the motor pulley.
8 Place the top panel on the Washing Machines and screw it in place.
9 Open the Washing Machines door and use your hand to rotate the drum counterclockwise a few turns to ensure the belt is secured.
10 Plug the Washing Machines into the wall unit and begin use .

Aug 02, 2011 | Washing Machines

2 Answers

Dryer does not work drum rotates but does not dry on hotpoint aquarius washer dryer model wd64. all other functions operate ok


Probably open circuit heater element, or thermostat/s
Remove top cover, and you will see the heater manifold on the top of the drum.
It is a long aluminium box.
The element and stats are located here..
You will need a meter to test the appropiate components for continuity.
Please rate my solution.
Thanks.

Nov 22, 2009 | Hotpoint Aquarius WD640 Front Load...

1 Answer

Loud bang during dryer rotation. front loaded dryer. dryer is six years old. bang is with evry rotation of drum.


not nkowing what brand, I would guess its a maytag or one of their brands. It sounds like a screw that mounts one of the paddles inside the drum has backed out and is now poking out the out side of the drum hitting the cabnet as it goes around. Un plug it , pop the top open , rotate the drum clock wise by hand slowly to see if a screw is standing up on drum.
If its a whirpool dryer with the lint filter inside the door, the top cabnet is dented down, hitting the drum.
someone sat on the top, bent it down.

Nov 21, 2009 | Washing Machines

2 Answers

The dryer drum does not rotate. The dryer


Hi,
There can be many reasons why your dryer2_bing.gif will not turn...

This tip that I wrote will help you to figure out what is happening...

Dryer2_bing.gif Repair - The Dryer2_bing.gif is not Turning
http://www.fixya.com/support/r4422207-dryer_repair_dryer_not_turning

Dryer2_bing.gif Repair ? The dryer2_bing.gif will not start
http://www.fixya.com/support/r4460438-dryer_repair_dryer_will_not_start


heatman101

Jul 16, 2009 | Whirlpool Gold Duet GHW9400P 3.8 Cu. Ft....

1 Answer

My thin twin dryer goes on but does not spin


your dryer has a belt! if you hear the motor going thats good.you will have to investagate further.the belt goes around the drum thru an idler pully then on to the motor

Jan 03, 2009 | Whirlpool LTE6234D Top Load Stacked...

1 Answer

Whirlpool Ultimate care ii Dryer wont tumble


If your dryer doesn't tumble, check these:
Belt,
Motor,
Door switch.

Your dryer can't operate at all if the door switch is defective. It's inside the dryer main housing near the door frame. Sometimes you need to raise or open the top or front of the dryer to reach the switch. If it's defective, you need to replace it.
Dryers have a drive belt that turns the clothes drum. If the belt breaks, the drum stops rotating. Then you need to replace the belt, and often the idler pulley, because the pulley tends to wear out at the same time.
If the dryer motor only hums when you press the Start button, the motor may be burned out. Here's how to test the dryer motor:

Remove the belt,
Check for obstructions in the blower fan housing,
Manually rotate the shaft of the motor.

If the motor is very stiff, or impossible to rotate manually, and the blower fan housing is clear, you need to replace the motor.

If the motor rotates freely, run the motor momentarily with the belt removed and the blower in place. If the motor runs fine with the belt removed, there may be a problem with the idler pulley or the clothes drum. Try to rotate the drum by hand. If it is very difficult to move, correct any problem with the rollers or pulley, and then reassemble the dryer and try it again.

Go here to see a diagram for your model:
one of two types. "H" or "J"

http://www.repairclinic.com/0079.asp#DiagramH

Nov 09, 2008 | Whirlpool Ultimate Care II LSQ9549L Top...

1 Answer

Dryer Drum not rotating


If warm air is still coming from the unit, but the drum is not rotating, it sounds like your drive motor is fine, but your drive belt is broken. Depending on you dryer model, these can be fairly easy to check, or may take a little creativity to get the dryer apart. Knowing your dryer model number would go a long way towards assisting further.

May 06, 2007 | Whirlpool LSW9750 Front Load Washer

Not finding what you are looking for?
Haier HLT41E Top Load Washer Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Haier Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1474 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Oloyede Monsuru

Level 3 Expert

1417 Answers

Are you a Haier Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...