Question about Jenn-Air JDR8895AAS Dual Fuel (Electric and Gas) Kitchen Range
The top oven doesn't get to the temp it says its at not sure if its the temp sensor or the bake element is bad and after using the oven it will beep and flash bake
you may have triped half your 220v breaker. (you should have shut it off when reparieng wire or it would have been live and zaped you) Or something in line with the wire that shorted blew out like a fuse in the range.
Posted on Nov 21, 2009
The baking element is probably the problem...
Check out this tip that I wrote about this problem...
Posted on Apr 09, 2010
Above is your parts diagram.
If the element melted then a considerable amount of current must have flowed through all attached Componentry. Including the Element switches which are most likely burnt out too, the contacts evaporate.
You also have Thermistor sensors these too most likely will be Open Circuit, you need to check with a meter, they should be SHORT CIRCUIT.
The sensors cannot be "Reset" they must be replaced.
You simply need to trace out where the wires go BACK to the controller, and see if you have voltage at this point, work back testing as you go, until you find the mains voltage again, the replace any components that are NOT passing the current through.
The circuit is pretty simple, from the mains IN switch, to the Element Control from the element control through the Relay, and onto to the element itself. The relay can also be "Turned Off" via the "Control circuitry" too.
Posted on Nov 12, 2010
SOURCE: bake element burned out on
You should have 120 to the element when not in bake mode, while in bake mode you should have 220 - 240 volt. Sounds like you lost a relay to send the additional power to the element, or you have a High Limit thermostat which could be open. This is a safety device to protect the unit from over heating, this only goes if temperatures increase higher the safety levels, normally set about 200 degrees or so along the air flow channels. I would trace from the elements to the clock and find the missing source of current.
I hope this helps
Be safe with electricity......
Posted on Jul 26, 2011
Testimonial: "Perfect! it was the high limit thermostat.Thank You for your help"
Tips for a great answer:
Aug 22, 2011 | General Electric Kitchen Ranges
Jun 12, 2011 | Maytag MER6751A Electric Kitchen Range
Apr 14, 2011 | Frigidaire PLEF398AC Electric Kitchen...
Apr 08, 2011 | Kenmore 91072 / 91074 / 91079 Electric...
Feb 21, 2010 | Maytag MER6772 Gemini Electric Kitchen...
Jan 19, 2010 | KitchenAid KERC607 Electric Kitchen Range
Aug 20, 2009 | Kitchen Ranges
Jul 20, 2009 | Amana AER5515QA Electric Kitchen Range
Jul 08, 2009 | Jenn-Air JGS9900BDS Stainless Steel Gas...
Feb 10, 2008 | Maytag MER6772 Gemini Electric Kitchen...
13 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: