Question about Lexmark X7170 All-In-One InkJet Printer

1 Answer

Lights BLINKING continously

When machine is plugged in the three lights for copy,fax and scan starts blinking. Unable to use machine for anything and the ink cartridges are full.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: Lights BLINKING continously

Don't waste your time with this site! If your printer is under warnety take it back. Otherwise, buy a new one. FixYa wants you to subscribe to their site for $20!

Call me cheep!!!!!! Call me feed up with it!!!!!!!!

Posted on Mar 09, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Konica Minolta Bizhub C353 Has not lights on the network card

make sure the new outlet has power coming out of it, It may be connected to a switch or the breaker may be turned off.

Oct 29, 2014 | Konica Minolta Bizhub C353 Color Copier...

1 Answer

When I turn my hp officejet 5510 all in one ink cartridge it says the print cartridge error see the product documentation for detail copy fax, scan are all blinking.

When lights stop blinking, you have solved the problem.

Nov 28, 2009 | HP Officejet 5510 All-In-One Thermal...

2 Answers

All the lights on my HP 1350 printer are blinking and it will not print. Normally where you could put the number of copies i " E" is in thaat spot.

In addition to providing information about current tasks, the lights on the front panel can also indicate error conditions, as described in the table below:
If the On light, Check Print Cartridge light, Check Paper light, and Start Copy, Black and Start Copy, Color lights are all flashing, do the following:
1 Verify that the front-panel overlay is attached to the HPPSC.
2 Turn your HPPSC off and on by disconnecting the power cord and reconnecting.


All ights blinking: An error caused the HPPSC to stop functioning.
1 Turn the HPPSC off and then on.
2 Restart your computer.
3 If the problem is not corrected, unplug the HPPSC and plug it in
If the problem persists, contact HP.

Apr 26, 2009 | Printers & Copiers

1 Answer

Won't copy or fax, scanner failure

Uneconomical to replace the scanner assy. sorry

Feb 17, 2009 | HP Officejet 4315 All-in-One Printer

1 Answer

Fax and cancel lights are flashing

I found this solution at HP website. It worked for me. Good luck!

A Scanner Bulb Error message is received as a result of the HP LaserJet 3300mfp series product scanner’s inability to find the home reference point.
Perform the following steps to walk the scan assembly from the home base and resolve the issue.
1. Remove and replace the power cord from the unit.
2. Wait approximately 35 seconds for the scanning assembly to “walk out" and then quickly remove the plug again.
3. Repeat steps 1 and 2, three to four times until the head moves approximately 1 inch away from its normal resting place.
4. Replace the plug and let the product fully finish the boot cycle.

Oct 08, 2008 | HP LaserJet 3330 All-In-One Printer

4 Answers

Brother MFC-5840CN unable to scan

From Brother Customer Service email:

You can try the following reset - it will most of the settings back to the default options.

Unplug power cord to the machine.
Press and hold down Menu.
Plug power cord back in.
Let go if menu when fax/scan/copy flash.

You may see either "maintenance" or "machine error xx" on the screen.

Type stop/exit, 9, 1.
The machine should show "param init" or similar to show that the reset is being done.

It will then go back to or machine error.

Type stop/exit, 9, 9.

This should take the machine out of maintenance mode and back to normal.

If the error is still present the machine will require an engineer to resolve the issue.

Jul 08, 2008 | Brother MFC-5840CN All-In-One InkJet...

2 Answers

My Dell AIO 962 Printer does not respond

The printer is dead and needs replacement. If covered under warranty, u can get a replacement from Dell. Speak to Dell support and they can give you alternative solution.

Nov 08, 2007 | Dell 962 Photo All-In-One InkJet Printer

1 Answer

Printer Issues

Take look at and trawl the site for your printer.

Jun 01, 2007 | Lexmark X7170 All-In-One InkJet Printer

2 Answers

Clear Memory

Try unplugging the fax machine from the outlet. Let it stand for awhile, plug back in. Memory should be cleared.

Oct 24, 2006 | Panasonic PanaFax UF-490 All-In-One Laser...

Not finding what you are looking for?
Lexmark X7170 All-In-One InkJet Printer Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexmark Printers & Copiers Experts

Roopesh S
Roopesh S

Level 2 Expert

228 Answers

Sanath Kumar V

Level 3 Expert

684 Answers


Level 3 Expert

18259 Answers

Are you a Lexmark Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides