Question about Hitachi 60UX54B/55K 60" Rear Projection Television

1 Answer

The tv turns on but no picture.

The TV will turn on but there is no picture. Sometimes the picture will briefly come on (1 second) and then immediately go back to black. The red light on the front DOES stay illuminated at all times.

Any suggestions?


Posted by on

1 Answer

Re: The tv turns on but no picture.

Mine did the same but no picture, just sound every few seconds for 1-2 seconds. I unplugged from the wall for 10 seconds and plugged back in, works fine now.

Posted on Sep 01, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

When I first turn on the TV the picture is messed up sometimes it shows a double picture.If I turn it on then off and back on again the picture is fine.Whats wrong? My second problem is that when I turn on...

Ur tv covergence board it is dying.Tv are developing a convergence picture problems.Tv have colors R,G,B lines mis alignments,have colors shadows pictures or 3D pictures look alike?Yes,than the tv convergence board it dying must require replacement like 2 STK convergence ICS and some or all of it resistors too.Fixed the tv convergence board to solved the tv convergence picture problems.The shop will cost u like $300-350 for parts and labors.

Jun 30, 2011 | Mitsubishi WS-55819 55" Rear Projection...

1 Answer

Sometimes the TV will not turn off, sometimes it won't turn on. It has also flipped through all picture formats (zoom, stretch, standard) on its own, had 1/2 the picture blank, and has randomly turned the...

I had a similar problem with my Phillips 42 in. LCD HD TV.

Here's the problem. The Power Supply Board. I opened my TV up(warranty was up of course) and found several bad capacitors. Phillips and several other companies were sold capacitors that although were highly rated failed within 5 years because of a lack of preservatives. All sorts of electronic equipment is now being effected due to these defective capacitors.
1. Take it in and have it fixed
2. Open it up, check the board for faulty capacitors(bulged or leaking) Buy a new Power supply board and install it.
3. Remove PSB, remove faulty capacitors and replace with compatible new ones.

Hope this helps

Dec 09, 2010 | Mitsubishi WD-52628 52" Projection HDTV

3 Answers

KDS50A2000 Green light comes on briefly followed by red blinking light. 4 on then pause, etc. etc. Problem???

I tried this solution last night. had a similar issue. opened up the back panel and cleaned the fan. just for the fun of it, i tried to turn the tv on and presto. it works fine now and i probably saved a bundle. thanks!!!

Jan 25, 2010 | Sony KDS-50A2000 50" HDTV

1 Answer

LG DLP Suspected Faulty Bulb... how to be sure?

First pull back off turn TV on watch Fan behind lamp more then likely it is going bad Fixed LG 9months ago and it was the Fan.If Fan Stops turning Lamp will not light.

Aug 06, 2009 | LG Projection Televisions

1 Answer

No picture on my tv

get a different tv but sel it first

Jan 11, 2009 | Projection Televisions

1 Answer

Mitsubishi vs-50609 wont stay powered on

Hello nicolastran,

I gave this advice to someone with this same problem so here it is again:

It sounds like your shutdown circuit is being activated. This is due to excess current being drawn. This usually happens in the High Voltage section of the TV or one of the deflection stages. Due to the nature of this problem I would suggest that you take it to a local TV repair shop or have a TV repair person come out and take a look at the issue. The HV section is dangerous and should be dealt with by a qualified TV repair technician.

Thank you,
I hope this helps


Jun 24, 2008 | Mitsubishi VS-50609 50" Rear Projection...

1 Answer

Whine-no picture-audio only,1 channel

bring up the menu screen the tv and auto program the channels this lock out all un wanted and only allow the rf tuner input channel from the box if your using rf cable hook up,if not un plug the unit for 1 min. and try it again.

Dec 11, 2007 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer

1 second red blink followed by 2 second blink on "status" led

there is a service bullietin related to this.. it has to do with a thermal sensor inside next to bulb..this sensor monitors the temperture of bulb... it says getting hot....this sensor needs to be replaced

Dec 04, 2007 | Mitsubishi WD-52525 52" Rear Projection...

2 Answers turns on briefly...solid color screen for a second...then blank?

I had the same problem about a 8 months ago. I searched online and found that there is a problem with one of the color guns. They need to be replaced. I don't remember where I found the information, but there is a number or something to call for this problem. I think that my authorized sony repair man knew of the problem, there are other models that have the same problem. Anyway, sony replaced all three guns in my tv FREE of charge, and my tv was no longer under warranty. They did all repairs and fixed my tv.

Aug 25, 2007 | Sony Grand WEGA KDP-57XBR2 57" Rear...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Hitachi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides