How do i watch multimedia messages on an evoke qa4

what is it, what is an EVOKE?

to ask a question on any technology (endless now)
tell what it is first. (ok?)
then tell all things it does good , bad or ugly.

all facts help, all evidence helps more...

Please,try downloading Motorola PC Suite from 'www.brothersoft.com' .Install it on you computer after download, then automatically all drivers for your phone will be available. Enjoy

You can get the Motorola EVOKE model mobile Unlock code and Instructions here
http://www.theunlockarena.com/motorola-evoke-qa4/rs13wp9/ and UNLOCK the Motorola EVOKE mobile....You can get the Instructions Below to know how to Enter the Unlock Code in it...

Motorola Evoke QA4 Unlocking InstructionsWarning : Do not enter any wrong unlock codes on your Motorola Evoke QA4 mobile phones. If you enter over a certain amount of wrong unlock codes on your Motorola Evoke QA4 mobile phone, your phone may get hard locked and sometimes become unusable.
1 - Switch ON your Motorola Evoke QA4 with a NOT ACCEPTED SIM Card,
2 - Phone will display "Enter Special Code",
3 - You can now enter the Unlock Code.

NOT ACCEPTED: We mean, to use a sim card from a network other than the network your Motorola Evoke QA4 is locked to.

WARNING: If one of theses messages appear :

- "Contact Service Provider"
- "Tampert Alter"
- "Wait before enter special Code"
- "Contact Service'

It's because you or somebody already entered too many wrong codes, you just have to leave the Motorola Evoke QA4 ON with the errors message and after 40 minutes to 2 hours the message "Enter Code Special" will appear again!

Your phone run on CDMA network which is already supported 3G. Think have some missing setting in your phone. Try "master reset" your phone!

Call the tech support for your cell phone provider and tell them you need to reset your unlock code.

i t is   software problem

7 times means the ink absorber is full. You need a new ink absorber #QA4-1012-000, about $10.00. But you need a shop to reset the error code after changing.

1. Press the "menu": Key
2. Press "Copy" Key
3. Press "#" Key

4. Scroll thru the menu headings until you come to "Test Mode" - 12th heading or select (-) as a short-
cut to the last setting.
4a. Press “Set” and the display shows:
Test Mode [1] – [8]
CF-FH3 :WLD-11-02

4b. Press “8” and the display changes to:
Test Mode [1] – [8]
Please wait

***note*** you have to wait until the display changes

Then the display changes to:
8: PRINTER TEST
[2]---[8]

5. Then Press the "3" button and the display shows:

8 – 3 : EEPROM Clear

*** the display scrolls to [0] : INK COUNT
[1] : 2PURGE FLAG

6. Press "0" button – for INK COUNT
7. Press the "Stop" button
8. Press Off then On to set new changes.
9. Printer feeds a blank page after it is turned on again.

This should Reset the printer and remove the WRONG CARTRIDGE error and save you a few dollars.

Replace all the Ink Absorbers.
QA4-1012-000
QA4-1013-000
QA4-1014-000
QA4-1015-000
QA4-1055-000
Reset the counter to zero.

Replace the printhead. QY6-0042-000 (now QY6-0064-000)
Should cost you about $54 if in the US.

This will only work a few times. Eventually, it will fail to reset
and you will have to replace the Printhead. I hope this helps.

you can purchase them here:
canon i9100 waste ink pad