Question about Televison & Video

1 Answer

When i turn it on its green then after 5 sec it

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 245 Answers

LOOKS THE SCREEN IS ON HIS WAY OUT.......U BETTER GET A NEW TELEVISION AS A NEW SCREEN IS VERY EXPENSIVE

Posted on Nov 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kindle fire won't turn on - even after full charge


Press power and volume+ button together until reset screen appears!

Jan 17, 2015 | Tablets & eReaders

1 Answer

How to run a diagnostic for washer model MHWE450WW01 Maytag


Starting Error History Software Version and
Diagnostic Test:
NOTE: Washer must be empty and the control must be in the
OFF state.
1. Close the door.
2. Select any one key (except "STOP/CANCEL" and "CONTROL
LOCK" and follow the steps below using the same key:
Press/hold for 2-5 seconds, Release for 2-5 sec, Press/hold for 2-5 sec, Release for 2-5sec, Press/hold for 2-5 sec
3. Upon release, all yellow/green console LED lights will turn ON
for 5 sec.
4. If there are any failure codes stored by the washer, the display
shows them.
Note: The last four errors will be displayed.
5. Press the same key to advance to the next code.
6. After the indication of error codes, the UI, CCU, and MCU SW
version will be displayed.
7. The number of cycles since last clean washer cycle is displayed.
8. All green console LED lights will turn ON for 5 seconds.
9. Next the washer begins the automated diagnostic test.
10.To cancel out of service mode, press the "STOP" button.

Apr 10, 2014 | Maytag Washing Machines

1 Answer

Nook hd wont turn on


Does this have anything to do with "Problem with Routers"?

Nov 13, 2013 | Computers & Internet

1 Answer

When I turn the set on green leds appear for about 30 sec then it swicthes to red stanby and flashes 5 times intermitently


Hi,

May I know what is the exact model number of your TV, it is located at the rear cover, manual, and on the receipt. It will help diagnose accurately where the fault came from and confirm the blinking error code.

Jdvillanueva

Jan 11, 2012 | Televison & Video

1 Answer

My red and blue crt go out and the green stays on


One or more of the CRT colors guns it dead,must be replaced.

Nov 03, 2009 | Sony KP-51WS500 51" Rear Projection...

1 Answer

It just turn on but the screen is green like 5 sec and turn back off


look for your sets "service" page not the regulae menu. Usually you have to hold the input buttin withthe power button for 2 secs. then you should get a very different menu, look for the factory settings and select that.

Apr 22, 2009 | Sony KP-57WS500 57" Rear Projection...

1 Answer

Samsung aircon turns in 5 sec. lights green/yellow flashing


check capacitor on outside unit,or gas is leaking.
try to reset(small black button in inside unit under the cover)

Feb 11, 2009 | Samsung Heating & Cooling

1 Answer

How do I connect my HBH-608 head set?


just turn on bluetooth in ur mobile and then turn on ur bluetooth headset by holding the power button for atleast 5 sec and if blinking green light show up it means that it is turned on,if it shows blinking red and green then it is ready to get paired with ur mobile phone so u can straight away connect the bluetooth by selecting handsfree and new device and in the list of divices select hbh608 and get it paired.if it shows a blinking green then hold the volume increase and decrease button at the same time for 5 sec and then the light turns blinking red and green and then u can go to handsfree and new device and select HBH608....its easy try doing that...it workss....

Jan 03, 2009 | Sony Ericsson Sony-Ericsson HBH608...

2 Answers

No picture no sound


Hi,

Probably, the selftest fails while turning on. If this is the case, press input&menu buttons at the same time for 5 seconds, then the green led will start to blink. Let me know how many times the led blinks.

Regards

Mar 01, 2008 | Mitsubishi VS-50609 50" Rear Projection...

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74630 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...