Question about HP Pavilion ze2000 Notebook

2 Answers

My power port will not work. it started by getting lose and then just not work at all, How do I fix it with out spending alot of $. Thank You

Posted by on

  • northerninsu Nov 19, 2009

    Is there any Video's that walk you through the job?

  • northerninsu Nov 20, 2009

    Thanks

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 788 Answers

The power jack is located inside the unit and not a easy part for the laymen to replace. It will require the removal of the Hard drive, battery, memory, keyboard and LCD lid.
Please keep in mind, if you are comfortable with the removal of the above, please feel free to go forward.
If not, the standard repair is about $100.00 and can be found on the internet.
Just type Bing and power jack replacement.
Hope this helps you and your problems are few.

Posted on Nov 19, 2009

  • John Ray Nov 20, 2009

    I am sure their is but you will have to research over the internet, to get that information.

    Again, if you were to put one screw in the wrong place, you could end up having to purchase another LCD.

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,281 Answers

FOr that you need to open cover of laptop.
Then you check that power port is soldered properly with circuit.
IF all is good then you need to change power port purchase power port from nearest computer shop it is very low cost then soldered .
Then it works again.

Posted on Nov 20, 2009

  • With 130$ you can get many types of charts facility but in 30$ only some type of charts are available.
    !30 $ has full features .


  • sorry for above answer.It is my mistake.

    There is not any vidio on web for fix this .
    But you can do it your own very easily.
    For opoen the laptop click on below link.
    click here

    click on aove link it helps you to find motherbord circuit.



×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power Steering Pump and Tensioner


if you have nor replaced one before then i say have someone do it. you end up taking off parts ( other brackets ) that have nothing to do with power steering, so you end up taking alot of other parts of until you get to the pump. it is alot of work. if you are going to do it? spend a couple of bucks and pick up a manual at autozone and it will show you step by step. sorry i have no video

Dec 17, 2013 | 2004 Chevrolet Aveo

1 Answer

My engine wont rev when warm


possible engine internal damage from the cold
have a compression test done
try testing the boost pressure from the turbo as it may not be working
excessive smoke and low power indicators
starts and runs cold is not indicated that it is a pump

Apr 06, 2017 | Cars & Trucks

1 Answer

My laptop Toshiba Satellite L505D-ES5025 got viruses and it stopped working, the USB ports and the audio stopped working when the virus entered in my laptop it used to get freezed alot afterwards so I took...


First, if possible, burn any important files to DVD (since you can't use the USBs) and shut down the Laptop. Then, press the power button and immediately begin to press "F8" 2-3 times per second until a menu appears with "Repair my Computer" highlighted. Press enter and follow the prompts until you get to another menu that offers a "Factory Restore". Click on this, it will warn you that you will lose your data, but in order to fix it this is necessary. I recommend choosing the drive option that formats the C partition ( do not format the D:Recovery Partition!) Toshibas typically take about an hour to finish. Make sure it is plugged in the whole time. This will work as many times as you want. Enjoy!

Jan 12, 2011 | Computers & Internet

1 Answer

Too much red in the screen


Hi and welcome to fixya, it is the colour wheel problem,,,,,,,,,this is common problem please check it ...it may be also cathode ray tube... thank u.........

Jun 03, 2009 | RCA P52812BL 52" Rear Projection...

1 Answer

REPLACEMENT FUSE WON'T FIT


instead of atc type fuses try mini fuse alot smaller

Apr 14, 2009 | 2001 Toyota Tacoma

2 Answers

New battery / alternator something pulling power from battery


loseing current <<<<--- As in Battery Draining Over night? Please Help Me Help You, I need More Details, Thank You

Feb 12, 2009 | 1996 Nissan Maxima

2 Answers

50"plasma


so you got the audio working correct? Sounds like it may be going into a protection mode of some sort now. I would try leaving it unplugged overnight and try again the next day and see if it starts working

Apr 30, 2008 | Televison & Video

1 Answer

When i plug my nano in my computer doesnt recognize it and says it malfunctioned but it plays music fine what do i do? ive tried the menu/center button method and disc mode nothing works im confused and...


First: try it on a different computer if you have one. You can even try it on a friends computer.
Second: do you have any other devices that are connected to the USB port on your computer? Do they work? Try the device that works in the same port that the IPOD was in and see if you get an error with the other device.
Third: You might have a problem with itunes. You could try uninstalling and reinstalling itunes and see if that works.
Fourth: There might be a problem with the usb drivers that windows uses to run the usb ports (are you running windows?) you can go into the device manager and goto the usb ports and delete them then have windows redect them.

Just a few ideas.

Mark

Feb 01, 2008 | Apple iPod nano

Not finding what you are looking for?
HP Pavilion ze2000 Notebook Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18389 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Tony

Level 3 Expert

2600 Answers

Are you a HP Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...