Question about ASUS P5LD2 Motherboard

1 Answer

The computer turns on but do nothin more....

I have a p4 3.2 processor,1gb of ram,a ge force 6200le.
i never use to have problems with my computer but suddenly he starts to rebbot and give a error message:"Bad Bios P5LD2-SE.ROM" and i restore the original bios settings a couple of times.But one time he rebbots and and the mother board seems to be dead....i turn the power on, but it has no beep and it doesnt appear nothing on the screen(the monitor dont detect any connection..).is the mother board fried or is a power supply problem??
(no burn smell when this happened and i open the computer box and it seems all fine).sorry for my possible english mistakes....

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,601 Answers
Re: the computer turns on but do nothin more....

It sounds like the BIOS chip is bad. if you cant reflash the BIOS, then the board is dead.

Posted on Jan 11, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer


For a Chaintech 9BIA motherboard;

Motherboard chipset is an Intel 845,

PC133 (SDR Sdram at 133MegaHertz;

{Single Data Rate. The proper term, not just Sdram.
Double Data Rate Sdram is Sdram.
Double Data Rate 2 Sdram is Sdram.
Double Data Rate 3 Sdram is Sdram.
DDR Sdram, DDR2 Sdram, DDR3 Sdram.

Synchronous Dynamic Random Access Memory )

Low-Density, Unbuffered, Non-ECC, Cas Latency of 3

(Don't get some cr@p off of Ebay.
It's usually high-density, ECC, that was used by old server computers)

WHEW! Unless you just want to run 1GB of ram memory, I would toss that board! (Two 512MB sticks) ->

-> Need two 1GB sticks of SDR Sdram at 133MHz

$400 smakeroos USD!!

Bah! That is just cra-zy!

Maximum TOTAL Amount is 2GigaByte. (2GB)
Maximum Amount for EACH ram memory slot is 1GB.

IF, you only have ONE ram memory module ('Stick'), it goes in Slot 1. (DIMM 1)
That is the ram memory slot closest to the processor socket.
The Processor reads ram memory Slot 1 first.


Nov 26, 2012 | Chaintech 9BIA (CT-9BIA) Motherboard

1 Answer

After turend on there are 3 beeps, no display, ram are ok tested

It is a memory problem. Verify if they are plugged in the mainboard slot.

Jul 13, 2010 | Intel DG965RY Motherboard

1 Answer

About my ram of p4m800-m7 rev 3.1 i have a 512mb ram already installed and i buy a new ram with a 1gb size and i would like to install it but my question is is it okay to put them together? my 512mb ram is...

The black rectangular chips on the side, or sides, of the ram module are DRAM chips. Dynamic Random Access Memory.

('Chip' is slang term to denote IC, or Integrated Circuit)

Each Dram chip is of a specific size, (or can be said as Amount)
There are manufacturers who make the Dram chips, and then the chips are used by the ram memory manufacturer.

Doesn't matter how the Dram chips are arranged. The ram memory manufacturer could put them all of one side, if they designed it that way.

1.Your motherboard will support, (Use), DDR at 333Mhz, or DDR at 400MegaHertz.
(PC2700 and PC3200, respectively)

2.The ram memory module must use 2.5 Volts.
(JEDEC has set the voltage standard for DDR Sdram at 2.5 Volts, so no worries here. Only time to check this, is if you have some High performance ram, that may be set to use a higher voltage)

3.It must be Non-ECC ram, and Unbuffered.

4.Cas Latency should be 2.5 to 3.0 (Ram Timings)

Short solution?

Computer off, and unplugged from power. TOUCH the metal frame of the computer case to relieve your body of Static.

Handle the ram 'sticks' by the body of the stick, and refrain from touching the gold plated contact pins, on the bottom.

If the 512MB stick is in SLOT 1, remove it. Install the 1GB stick in Slot 1. Make SURE it is seated!

(Slot 1, is the ram memory slot that is closest to the Processor. It is the first ram memory slot that the Processor reads)

Leave the computer case open. (Refrain from putting your hands in while the computer is plugged into power)

Plug the computer into power. Wait 30 seconds. Turn the computer on.

Computer boots up? (Starts)
Unplug from power. Install the 512MB stick in Slot 2.
Plug into power, wait 30 seconds. Turn the computer on.
Computer boots up?
You're good to go.

1GB ram memory stick is in Slot 1, and the computer does not boot up?
Incompatible ram memory. Remove it. Reinstall the original 512MB stick in Slot 1.

Nov 26, 2009 | EliteGroup P4M800-M7 Motherboard

3 Answers

Trying to upgrade RAM on GA-945gzm-s2 mobo. Already have 1gb 5300 ddr2 stick of RAM. Works fine until I place the 2nd stick of RAM in. I turn it on and get no post beeps, no video, but everything is...

The new RAM module could be faulty or the second memory slot is faulty.
Try removing the original 1Gb memory module and inserting the new memory module in its place to see if the computer boots up normally. If it doesn't then then new memory module is faulty.

Oct 24, 2009 | Gigabyte GA-945GZM-S2 Motherboard

5 Answers

Can you run vista on this motherboard

Go to the website of the motherboard. Find your info.

Sep 01, 2009 | Foxconn (945G7MA-8KS2) Motherboard

1 Answer

Promble with Ram

No the problem isn't the ram, or video card, or lack of video cards.

The problem stems from using a 32 bit O/S, (Operating System), like Windows XP Home, or Windows XP Pro. (The 32 bit version of XP Pro. Microsoft made a 64-bit version of Windows XP Pro)

A 32 bit O/S will only 'recognize' UP TO 3.2GB's of ram. (Sometimes up to 3.5GB's)
You need a 64 bit O/S so that your computer will recognize all 4GB's of ram, when it is installed.

32 Bit? 64 Bit? What is all of this? It's kind of hard to explain in a few sentences. I would like to refer you to these links on Wikipedia, to explain 32 bit, and 64 bit further,


Jul 14, 2009 | Motherboards

1 Answer

Dear Sir i have pentium 4 motherboard 865gbx and i wanted to upgrade the ram. so maxixmum how much ram it will support and wat shd be speed like..333mhz??

IT supports Maximum 2GB DDR400 RAM.
It mainly depends on the Processor speed.I think 1gb RAM is sufficient for Your Pentium 4 configuration. If you use more than 1Gb.there is no remarkable speed difference between them.So better choice is use 1GB RAM.

Jun 24, 2009 | Intel PENTIUM-4 865GV CHIP MOTHER BOARD...

2 Answers

Vista compatiable

intel doesnt list any vista drivers for that motherboard on there site so you might run into problems with the intergraded devices such as the ethernet,audio,chipset, & any intergraded video

You might be able to use the xp drivers but if theres problems it wouldnt be supported by intel

Nov 26, 2008 | Intel D101GGC Motherboard

2 Answers

DDR2 533Mhz 2 x 1GB

the DDR IS THE RAM , the processor and the ram and a good motherboard work and produce a beep,
remove the processor and the ram, get other working processor and the ram and try on your system, it works troubleshoot the removed processor and ram to find out the bad one and it does not work, your motherboard is dead.


Feb 12, 2008 | EliteGroup P4M800PRO-M Motherboard

Not finding what you are looking for?
ASUS P5LD2 Motherboard Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top ASUS Motherboards Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Sudeep Chatterjee
Sudeep Chatterjee

Level 3 Expert

3267 Answers


Level 3 Expert

2598 Answers

Are you an ASUS Motherboard Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides