Question about LG WM2077CW XL Front Load Stackable Washer with 7 Washing Programs

1 Answer

LG WM2077CW (UE error code)

I purchased this LG washer WM2077CW about three months ago, it just recently started to act up. I constantly get an error code pop up at about the 10 minute mark. The manual says its an unbalanced load and I need to balance the load out. I have tried many times to re-adjust the load evenly and I even taken some of the clothes out to lessen the weigh in the drum. After pressing start the wash countinues but the time does not move foward it remains at 10 and within minutes it will show the UE error code again. It wont even start the rinse cycle nor spin to start it. It goes back and forth before showing the UE error code. I have take all the clothes out of the wash and start the machine all over. I let it run through the entire wash cylcle until it get to the point where I took the clothes out then I put the clothes back in when the rinse cylce start/where I took them out to complete my prior wash. That is the only way I can get a complete wash out of this machine.

Posted by on

  • 1 more comment 
  • ZEUS1009 Mar 18, 2008

    I also get this problem have to do the same thing remove all the wet clothes this happens too much the load is not over fulled



    also get a LE CODE CALL FOR SERVICE HAPPEN THE FIRST TIME I USED WASHER HAVE TO UNPLUG THEN START OVER THIS IS CRAZY

  • frazzaj68 Mar 16, 2009

    I have the same problem and I know the washer is not too full or unbalanced. I have to wring clothes out brfore I can place them in the dryer, the error code is UE, can anyone give advice on what the problem is, I will have to fix it out of my pocket, I am a single mom of 3 kids so I am looking for the cheapet way to fix this. Washing Machine is LG washer WM2077CW

  • frazzaj68 Mar 16, 2009

    I have the same problem and I know the washer is not too full or unbalanced. I have to wring clothes out brfore I can place them in the dryer, the error code is UE, can anyone give advice on what the problem is, I will have to fix it out of my pocket, I am a single mom of 3 kids so I am looking for the cheapet way to fix this. Washing Machine is LG washer WM2077CW

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,294 Answers

For "ue" an unbalanced load is sensed three times; re-adjust your load in the machine. What is the capacity of your machine, you could weigh your dry clothes........refer manual.

For e1, it could be a water sensor problem. Check to see if the inlet valve is okay and not clogged, water shd be in good pressure. If this is okay, open up behind after taking the plug off the wall. There is a thin tube coming from the switch area to the outlet pump area; disconnect this from the top carefully and blow into it, it should be free; if it is clogged you will hav a water level problem. Unblock and refit carefully.
.....& rate me if helped.

Posted on Jan 29, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

UE Error Code on LG Tromm Washer


From back or underneath, check that all three shock absorbers are attached. Take top off and check if both springs are in place and un broken

Mar 22, 2017 | LG Tromm Front Load Washer And Dryer Set

1 Answer

ERROR CODE LE ON LG FRONT LOAD WASHER


LE is a locked motor error. Not to worry as 95% of the time it is just a bad hall sensor (the motor position sensor). For your model the part number is 6501KW2002A.

May 28, 2010 | Washing Machines

1 Answer

WM1814CW Front Load Washer: UE error code on display...


UE is Imbalance error..Redistribute the load or you may have tried to wash something which will not 'spread' enough to balance the load...Nomess

May 16, 2010 | LG WM1814CW Front Load Washer

1 Answer

Ue error code on my LG WASHER


Hi there
hope this helps you .
UE - Unbalance switch error Unbalanced load is sensed three times during a spin operation. Open lid. Rebalance laundry load and close lid.
· Check wiring harness
· Check unbalance switch
· Check circuit board thank your for writing to fix ya.
Best regards Rich

Dec 08, 2009 | LG WD-16115FD Front Load Washer

1 Answer

"UE" error code LG washer wm0642hw


This is an Imbalance code. Your issue may be with:

  • The load is too small
  • The appliance is tilted
  • Laundry is gathered to one side
  • Non-distributed things are put into the drum
Try adjusting the load size, and make sure the unit is level.

Aug 07, 2009 | LG WM1814CW Front Load Washer

1 Answer

Error code UE on LG Front Loading Washing Maching


this is what i just found on the internet...
With any washing machine, it is vital to ensure that the load is evenly balanced when using a spin cycle. Redistribute washing by adding or removing items to ensure a more balanced load. ... If the door remains locked and the machine is displaying UE error, please run a drain program.5 Jul 2016

My Samsung washing machine is showing a UE code during a spin ...

or try this link..
Error code UE on LG Front Loading Washing Maching Google Search

Oct 27, 2017 | LG WM1814CW Front Load Washer

2 Answers

Code error ue lg washing machine


ue is (imbalanced error) cause. the load is to small,washer is tilted, laundry is gathered to one side, non distributed things are put into the washer

Jun 20, 2008 | LG WM-2077C Front Load Washer

7 Answers

Ue error code on the display


For "ue" an unbalanced load is sensed three times, re-adjust your load in the machine.

For e1, it could be a water sensor problem. Check to see if the inlet valve is okay and not clogged, water shd be in good pressure. If this is okay, open up behind after taking the plug off the wall. There is a thin tube coming from the switch area to the outlet pump area; disconnect this from the top carefully and blow into it, it should be free; if it is clogged you will hav a water level problem. Unblock and refit carefully.

Sep 23, 2007 | LG WM1814CW Front Load Washer

Not finding what you are looking for?
LG WM2077CW XL Front Load Stackable Washer with 7 Washing Programs Logo

985 people viewed this question

Ask a Question

Usually answered in minutes!

Top LG Washing Machines Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1474 Answers

Marvin
Marvin

Level 3 Expert

82322 Answers

Are you a LG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...