Question about Onkyo TX-SR500 Receiver

1 Answer

Onkyo Tx-SR55 My Onkyo TX-SR55 Front speaker right channel is not working properly, everything works fine except for the right front speaker, it hums and crakles. HELLLLP.......

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 4,402 Answers
Re: Onkyo Tx-SR55

Did you swap the left from speaker with the left front?
if still crackels after that them you have bad left output.

Posted on Jan 09, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Shorted binding post

The front right channel audio output semiconductor will need to be replaced, and i recommend a qualified technician because this will be a complex repair.

Mar 19, 2012 | Onkyo TX-DS494 Receiver

1 Answer

One channel not working onkyo tx-sr04

You might have to take a look into the unit, there could be some damage or a bad solder connection on the front left speaker connector at the circuit board, possibly also on any other component (power amp chip / transistors, internal connectors, etc.), also loose or broken wires or oxydized connector contacts inside the unit.

It could be something else as well, but i guess it's worth checking the above mentioned.

Hope you can fix it


3rq8 (Triarcuate)

Aug 08, 2009 | Onkyo TX-SR604 Receiver

1 Answer

Righ & Left Front speakers not functioning


Mar 15, 2008 | Onkyo TX-SV545 Receiver

1 Answer

Right front channel sometimes does not work

you have dry solder joints in the output stages to the front channel.-solution. resolder channel.... or dirty speaker protection relay contacts. can be determined by tapping the top of the protection very gently when fault occurring. solution. burnish contacts and treat with crc2-26

Oct 20, 2007 | Onkyo TX-DS676 Receiver

1 Answer

Onkyo TX-SR500 Dolby Digital problem

I just read over the problem you were having with your Onkyo TX-SR500 receiver. It sound like the unit needs to be setup for all five channels.Sence your symptom says the diplay shows Dolby D3/2.1. According to the owners manual with the remote control look for speaker setup whin the button is pressed the current speaker setup will be shown in the display. Press the preset/adjustment<> to change the current setting to five speakers. the listening mode will automatically change according to the number of channels you selected. Hope this helps. Radiotech

Aug 14, 2007 | Onkyo TX-SR500 Receiver

1 Answer

NO surround sound coming from our harmon/kardon speakers when set up to our onkyo tx-sr601 receiver. wires connected in correct areas, front left, right and center speakers work, subwoofer works. setup for...

So your saying that you have no rear channel. Some recivers use a single stereo output ic for both sides on the rear speakers. you could have a defect with this IC . Anther thing Im sure you check3ed the obvious ie : the switch is on suround sound? If there is a front to rear fader is it in the middle? Good Luck

Jun 04, 2006 | Onkyo TX-SR601 Receiver

Not finding what you are looking for?
Onkyo TX-SR500 Receiver Logo

275 people viewed this question

Ask a Question

Usually answered in minutes!

Top Onkyo Audio & Video Receivers Experts

 Mike M
Mike M

Level 3 Expert

3320 Answers

D. E. Hev

Level 3 Expert

1059 Answers


Level 3 Expert

2963 Answers

Are you an Onkyo Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides