Question about Computers & Internet

1 Answer

The screen become black for a while then there is emerged blinking light as same as ram failure

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

In safe mode ( f 8 ) Uninstall driver grafig

Posted on Nov 13, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Dell inspiron laptop N5040 3 beeps interval 3 beeps black screen

Explain the intervals at which it beeps, either 2 short beeps and a prolonged beep. does the hard disk LED blink? if it does its display inverter problem. if no blink on hdd LED its either RAM or cpu failure.

Oct 04, 2013 | Dell Inspiron Computers & Internet

2 Answers

Black screen wont boot little blinking dash left hand upper coner

One Blink repeating. >>CPU not functional.
Two Blinks repeating.>> BIOS corrupted.
Three Blinks repeating.>>RAM Module Error.
Four Blinks repeating.>> Graphics Card Failure.
Five Blinks repeating.>>Other Systemboard failure.
Six Blinks repeating. >>BIOS authentication failure.

Jul 19, 2010 | HEWLETT-PACKARD HP Mini 110 101Inch Mobile...

1 Answer

The screen is black and will not turn on. Light

change the RAM because such problem occurs when RAM is faulty

Feb 12, 2010 | Computers & Internet

2 Answers

Sony kf 50e200a screen goes black and sound turns off for min...

TV has gone into "protect mode" to do just that to protect against the damaging failure that has been detected, you will need a servicer to diagnose the failure. Good luck and Merry Christmas!

Dec 25, 2009 | Televison & Video

1 Answer


Sounds liek your hard drive has failed, search ebay for this model of laptop with hardrive at end of yoru search, not 100 percent sure but im nearly 90 percent sure its hard drive failure.

Dec 03, 2009 | Gateway P-6313 Notebook

2 Answers

Acer black screen no beep with memory taken out

Check if you have image connecting an external monitor to laptop.

Oct 17, 2009 | Acer Aspire 5100 Notebook

1 Answer

I have a lct 2715 not too long ago the screen went black and the power light blinks yellow

The failure with your LCD might be due to defective capacitors in the power supply. These parts become defective due to excessive heat and fail prematurely If you are able to DIY, you can check the picture to see how defective capacitors look like.901ae86.jpg

Oct 01, 2009 | Akai LCT2715 27 in. LCD Television

1 Answer

Latitude d630 caps lock on with black screen with blinking light

Your RAM is either bad or not seated properly. One RAM stick is in the bottom of the laptop (underneath the windows sticker); this one is accessible by removing one screw. The other is underneath the keyboard. To get to it, you have to pry the thin panel near the top of the keyboard with the buttons on it off. Do this with a thin screwdriver on the right side (you will see a tiny indentation in the surrounding plastic) and pry it up on that end. Use your hands to remove it the rest of the way to the left. Then unscrew the 3 screws holding the keyboard down at the top and pull the keyboard toward the monitor and up. It should come mostly free, but don't do this too hard such that the keyboard cable becomes unseated. You will be able to see the RAM chip near the touchpad.

You should make sure both RAM chips are well seated. If they are, take one out and start the computer. If the problem persists, withdraw power and change which RAM stick is in. If the problem still persists, you either have two bad sticks, two bad RAM slots, or other problems (like motherboard) developing.

Jul 17, 2009 | Dell Computers & Internet

1 Answer

Blinking red light code and screen turns goes black then turns on

5 blinks is code for lamp driver failure.Replace ballast.

Apr 26, 2009 | Televison & Video

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Computers & Internet Experts

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers


Level 3 Expert

102366 Answers

David Payne
David Payne

Level 3 Expert

14161 Answers

Are you a Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides