Question about Kenmore 67082 Electric Dryer
I took out a load, and put in another, pressed start and nothing happened. No lights, no nothing!! The dryer, by the way was cool. Checked circuit breaker, 220 power and not a clue. There is 110 power because the drum light comes on. Had a repair man come and he worked for over an hour and could find nothing. Fuses all good, and wiring good also according to him. Maybe the computer panel?? HELP ME PLEASE!
I have the6705*,6706* or the 6707*, anyways the af light is activated. I completely cleaned out the lint filter, cleaned the electronic sensor had lint on the contacts, cleaned the lint from the vent from floor to roof, the af light still activated. I can run the dryer, but when the dryer is off, the af lights turns back on then will flash on or off if you hit the start button. The manual states something about letting it reset for the amount of time that is listed after you hit the start button. I have not seen any minutes the light and the beeping is not as frequent. What Do I Do?????
Posted on Oct 16, 2008
These are awesome solutions, L1 or the black hot wire supplies the lights and one leg of the heater while L2 the red power wire completes the circuit for the heater and powers the board. A great test is this, if the light is on and the load doesnt go, bad load. In this case trace the L2 line and find where the power stops, the first is the interface and the same goes for Frigidaire. I would also get the part number from Sears, tell them you will wait for money and then look for other local sources, it is worth the wait to save 80 dollars for a back order.
Posted on Sep 13, 2008
I fixed it by replacing the user interface. The part cost a ridiculous $190 w/ shipping and all from the sears catalog. The dryer itself was over priced and lasted long enough to exhaust the 1yr warranty. Kenmore products ****, I'll never buy that isht again.
Posted on Apr 01, 2008
I have the same problem only the drum light will come on i opened up the top console and found the tech sheet and after going thru the tech sheet with a multi-meter according to the results i will need to replace the user interface assembly, p/n 3407184. you too may have the same problem.
Posted on Mar 31, 2008
Tips for a great answer:
Dec 12, 2015 | Kenmore HE5 Electric Dryer
May 12, 2012 | Kenmore Elite Oasis 6808 Electric Dryer
There can be many reasons why your dryer will not start or turn...
The most common causes are the belt breaking or jumping off, or the motor going bad...
Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...
Dryer Repair - The Dryer is not Turning
Dryer Repair - The dryer will not start
Feb 16, 2011 | Kenmore Elite Oasis 6808 Electric Dryer
If your dryer doesn't work or start please check the bellow link to troubleshoot your problem :-
Please get back to us if you have further query else please accept the suggestion.
Feb 02, 2011 | Kenmore Elite Oasis 7808 Gas Dryer
Jan 18, 2011 | Kenmore Elite Oasis 6808 Electric Dryer
Oct 04, 2010 | Kenmore 67082 Electric Dryer
Mar 19, 2010 | Kenmore Elite Oasis 6809 Electric Dryer
May 20, 2009 | Kenmore Elite Oasis 6808 Electric Dryer
Nov 16, 2008 | Kenmore Elite HE4 Electric Dryer
Mar 31, 2008 | Kenmore 67082 Electric Dryer
618 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: