Question about Vacuums

2 Answers

How do l get to yhe filter for my hoover breeze U1432 vaccum

Posted by on

  • 1 more comment 
  • jacquicottre Nov 12, 2009

    Hi Lee thanks for your reply.Unfortunetly my vacuum is a Hoover Breeze Model U1432.Its quite old and l can see were the filter should be but cant get to it l have screws out and bits of it everywhere.Its not in the hanlde part but on top of the bottom part lol gee does that make sense?



    Jacqui

  • jacquicottre Nov 12, 2009

    Anybody out ther interested in my problem for finding and retrieving the filter in my Hoover Breeze U1432 Vacuum Its driving me nuts!!!!!!

  • jacquicottre Nov 12, 2009

    Thanks everyone for your help all fixed Jacqui

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,741 Answers

You will have to get the user manual/service manual from the service center of hoover to locate and get that part(filter).as the unit is bit old you will have to get the maual
this is the direct link for hoover service center
http://www.hoover.com/CustomerService.aspx
you will have to place the order here and they will send you the manual.

How do I get a new Owners service Manual? The Answer is... Click here and review the available on-line manuals. If you do not find the appropriate manual, contact The Hoover Company Consumer Response Center at 1-800-944-9200 M-F 8 AM - 7 PM EST

Posted on Nov 12, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,472 Answers

Http://www.hoover.com/pdfs/manuals/H3000.pdf
Just follow the link above and refer to page 7 and 8 of the manual for the exact instructions.
Thanks and enjoy,
lee

Posted on Nov 12, 2009

  • Lee A.
    Lee A. Nov 12, 2009

    Hi,
    there aren't any resources online for that model. I would suggest you contact hoover directly for a manual on the vacuum.
    customer service department at 1-800-944-9200 M-F 8 AM - 7 PM EST.
    Thank you and good luck,
    Lee


  • Lee A.
    Lee A. Nov 12, 2009

    bump

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lid of filter section stucked in Hoover Vaccum Cleaner Model UH70115


Hi Bharat! In the front of the dirt cup near the top there is a red Hoover emblem that is also a latch to open the dirt cup lid. Pull on dirt cup latch to open lid. Hope this helps!

Sep 17, 2014 | Hoover UH70015 Bagless Upright Cyclonic...

1 Answer

Demonstration of how to use hoover vaccum cleaner u5759-906


Hi
What happened to the manual?
Online you can find MANUALSONLINE.COM see if you can find the Hoover manual there.
all the best
Kolbrun

Mar 07, 2012 | Hoover Vacuums

2 Answers

Hi My Hoover wind tunnel cyclonic stopped working when i was using it. I tried different plug even then it doesnt work . What to do??


If the motor stopped running, it most likely did because it was not being cooled, becuause something was stopping up the air flow. If you have cleaned the secondary filter out and it still stops while running, then remove the exhaust filter cartridge and try it then. If it does not stop running now, then the problem is the previous models like this had a foam filter as the exhaust filter, not a heppa cartridge filter. You will not hurt the machine by running it without the heppa cartridge. Cut a foam filter to fit to replace it. I do not think Hoover knows this yet.

I have a customer working on this problem today (Sept 2010) I have repaired machines for 30 years. This filter is meant to just catch the tiny particles from getting back into the air. However, it worked fine on the previous machines with the foam filter here instead of this Heppa cartridge.

Dave in Texas

Aug 31, 2010 | Dirt Devil Hoover Uh70085 Pet Cyclonic?...

1 Answer

I bought it in may , I can honestly say , it is THE worst vaccum


There are several filters on bag-less vacuums that need to be cleaned. Dig out your owners manual or open the one below. See section 3 for filters and maintenance. If you are vacuuming a house bigger than about 1500 square feet, you should be cleaning the filters every other use. Personally, after using a bagless for a couple of months, I went back to my bagged vacuum.
http://www.hoover.com/pdfs/manuals/U6630900.pdf

Dec 20, 2009 | Hoover U6630-900 WindTunnel Bagless...

1 Answer

No suction


have u checked all of the filters. I know that when not all the filters r clean the machine will turn on but then it will sound louder and still have no suction. Most times there is a filter under dirt container thats sits above motor and if this filter is not clean the motor cannot breath. Thus no suction

Sep 29, 2008 | Hoover U6630-900 WindTunnel Bagless...

1 Answer

How to fix wheels on hoover vaccum cleaner


i cant get the back wheels off my mach 3 hoover vacuum can anyone help?

Jul 14, 2008 | Hoover U8145-900 Savvy Bagless Upright...

1 Answer

Dust blowing out of hoover


http://geeksquad.fixya.com/ThreadView.aspx?prdid=618781&thid=617336
Dust blowing out of Hoover
Posted by Lunagus on May 23, 2008
When I start up my year old Electrolux Loopie Petlover vacuum a large amount of dust comes out of where the HEPA filter is - can you suggest reasons?


Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. Oreck Upright 014T XL Pro 14 Upr Vac

In answer to your question, if the HEPA filter is leaking then you should replace it because it has lost it’s filtration – but my question is – is it on the Oreck, Hoover or Electrolux --- all three have HEPA filters and needs replacing and to make sure that the HEPS filter is installed correctly or other wise the filter will leak and if that happens then contact your local vac dealer in your neighborhood. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
http://www.hoover.com Telephone
Contact our Customer Service Department at 1.330.499.9499
Monday through Friday
8 a.m. - 7 p.m. EST

http://www.oreck.com/ Customer Service 1-800-989-3535
Monday thru Friday Hours are: 7:00 am to 7:00 pm CST
Saturday and Sunday Hours Are; 8:00 am to 4:30 pm CST
http://electrolux.com/ Customer Service 1-800-896-9756
Electrolux Home Care Products – North America
P.O. Box 3900 Peoria, IL 61612
Thanks, Don the Vac Man
Go Ahead. Use Us.

May 23, 2008 | Oreck UPR014T XL Pro 14 Upright Vaccum...

1 Answer

Hoover Wind Tunnel Problem


motor burnout. replace the motor or get a new vacuum

Dec 15, 2007 | Hoover U6437-900 / U6439-900 Windtunnel...

Not finding what you are looking for?
Vacuums Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Vacuums Experts

AskDyson
AskDyson

Level 3 Expert

2572 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18390 Answers

D. Floyd Kolb
D. Floyd Kolb

Level 3 Expert

43501 Answers

Are you a Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...