the controller for the Runco PL-50HDX turns on but the display does not. the control cable is connected and the display status light blinks 'once' when the power button is push. tried a factory reset on the controller and same issue.... controller on and display is not
I have the same problem with an HP PL4260N plasma--just a little over one year since I purchased it....
(More)
I have the same problem with an HP PL4260N plasma--just a little over one year since I purchased it. I called and got the same offhanded--who cares attitude and they said it would cost about $625 to replace the ysus board. They seemed to know immediately what the problem is. It looks to me as if this is a known problem and I think HP should do something about it. I will never buy HP products of any kind again. MM Grand Junction, CO
I have a digital cable connection but when I go direct my Tevion HD ready LCD TV says, no signal....
(More)
I have a digital cable connection but when I go direct my Tevion HD ready LCD TV says, no signal. But there's no problem when I use the scart connection from my old DVB receiver. Do I need an external receiver????? I'm in Germany but my german is not good enough to read the manual.
Display monitor when powered on will display a picture with extreme reddish tint in it before...
(More)
Display monitor when powered on will display a picture with extreme reddish tint in it before powering off and flashing on front of monitor meaning an error. I need to find out which board is malfunctioning to replace it. Runco 50in Cinema Wall Display Monitor.