I have a Hobart Kitchenaid Superba kds-20 and I

How-To Unlock A Kitchenaid Superba Oven - YouTube

? 1:24
www.youtube.com/watch?v=yKNGTVCEiuM
Sep 22, 2014 - Uploaded by Public Relations & Promotions
How-To Unlock A Kitchenaid Superba Oven ... Repair - Deadoven after self clean mode, blank display, locked door Kitchen

KitchenAid Dishwasher Model KDS 20 KDS20 KDS 20 Parts

next to the compressor is a relay called a klickson

You can get engineer to replace for about $120 or buy one for about $20

The Brush holder caps / covers for the K5 series whether Hobart or Kitchenaid by Whirlpool (after 1986 when Whirlpool bought Kitchenaid from Hobart) will fit the K5-A they just wont be flush like the older Hobart caps. They come in black or white.

go to appliancerepairpros.com or repair clinic .com..good luck...

kitchenaid didnt make that d/w, hobartmade it for kitchenaid, thats why they are still running from the 1960's the mod# from hobart should be a wm5h

It may have leaked some water on one of the electrical parts and made the smell. Leak could have been from a dirty gasket, so check the gasket and clean it up with just a few wet paper towels.

It could also have been a solenoid that failed and overheated, but since it went through the cycle it sounds like maybe it's okay.

If it is an electrical part, then they are not too hard to get. There are several stores online and brick and mortar that will help out.

That would be incorrect. If the attachment is for a hobart kitchenaid mixer then it will fit all models of kitchenaid mixers including the brand new pro series because the attachment port and drive gear has not been changes since 1925 or 6 when it was first introduce by the Hobart company.

If i remember correctly, a KD7 was built in the 70's or early 80's, we used to service them before being sold to Inglis. Seeing it uses the same water solenoids to fill, and asuming it is filling ok, I would suspect worn arms and hubs. If it doesn't fill completely, the fill valve coils may be opening when they get hot from the water flow. The fact that you need a new rack would indicate wear thhoughout and may be too old to justify repair. Find your local Inglis dealer to check on parts availability.

http://www.kitchenaid.com/custserv/service.jsp

Enter your model number and it will give a listing of the manuals available to you.