Our New World gas oven is just on two years old (i think) when we use the grill it keeps clicking and then it just shuts itself off as though there is no gas getting to it. The pilot light will continue clicking . Can you help please.

check with multi meter ur oven safety gas valve and more than likely ur igniter switch? although the oven safety gas valve dont commonly go out it may somehow have shut off the gas as it has an on/off button usually red in color that can be tripped? check to see if its in off position

indicates the oven door is not closing properly
get a technician out to check and adjust the hinges

They won't pack up.. The fan is there to circulate the warm air. It might not heat up or cook as quickly as it used too. It will not cost much to fix though, labor will usually cost more than the part itself.

Good Luck

* If you found this solution helpful, please vote positively.

this unit has a gas coil controling the valve . and wen it gets hot it is failing and cannot keep the gas on . replace the valve coil // mm

The regulator that comes with Weber grills shuts the gas flow off if it detects the slightest leak. Disconnect the tank an reconnect. Check connections with soapy water for any leaks. Another problem, though uncommon for a new grill is a defective regulator. You have a 1 year warrenty on your grill so contact Weber if you continue to have problems.

HI it could be agas pressure problem meter pressure too high get the gas company to check it out for you

Leave the door open in the broiler position, about 4 inches.

THIS IS PROBABLY BEST LEFT TO A QUALIFIED ENGINEER. To reset the grill thermal cut out. This is located under the metal panel at the top of the unit and it is necessary to ether partially or fully remove the whole oven from its housing to get at it. 1. Disconnect electric supply. 2 remove the 2 housing retaining screws. These are located either side of the at the top of the grill cavity. 3.Pull the whole oven /grill unit out and support it underneath to stop it falling forward. 4. Remove metal cover covering top of oven. 5. the safety cut out is a small component that has 2 wires connected to it by spade terminals, in the middle of which is a small red button. push this button gently with the end of a pencil or screwdriver until it clicks. This should now be reset and allow the gas supply to the grill to resume. Finally reassemble making sure that the integrity of the gas and electrical supplies are, in no way compromised and test.

Hi

Forgive me for asking this, but you have read the instructions haven't you?

If you have, and it's still not working, then the likelihood is that there is a fault, this could be one of the following:

Faulty solenoid valve to grill (some grills had a safety button fitted to stop you from closing the door if the grill was being used)
Blocked pipe inside unit

Either way you need to get a qualified gas engineer to take a look at it, if it's under warrranty call the manufacturers first!

I hope this helps

Steve :)

my jen-Air has a problem with it continuing to beep. Ive tried to get it to stop by pushing all the buttons. When I pust the off/cancel button it just keeps beeping. Tried the stop timer button and same thing. When I turn on either the bake or convection bake button it automatically just shuts off by itself. It is approx 10-13 years old. HELP, or please tell me to get a new one.