Question about Washing Machines

1 Answer

Aeg w1059 there is no water coming through to my washing machine,i have checked the pipes and ther is water coming through them but not into my machine..any ideas?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers
Re: aeg w1059

If you know for sure that water is flowing TO the washer's water hoses, then the water solenoids must be bad. Listen to see if you can hear both the cold and hot water solenoids buzzing (use the cold & hot water temp switch to switch back and forth). If they're buzzing, then water should be flowing, but if not then water cannot flow because they're not mechanically opening up (they are bad).

If you need more info, I'm at

Posted on Jan 05, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Aeg lavamat 50600 does not take in water

check water supply tap is on. check water to water supply tap is on. if both is the case and you haven't plumbed in the water supply yourself about three or four years ago with one of those self cutting pipe take-offs. then it's probably the inlet valve. take the top off and the back off. its attached to the back of the powder tray assembly more often than not.

Feb 26, 2013 | AEG Washing Machines

1 Answer

Whilst wash on, water leaks from the underneath of washing machine. but cant see where it is coming from

if the water is leaking during the fill cycle when the detergent is being added from the drawer
ensure the draw is clear, if too much deturget rests has blocked the vent then water maybe running out on the inside.

if the problem is happening during the wash cycle this indicates a leak on your drum, ensure your door seal is intact and not leaking.

if the problem is during pumping, ensure that the pump is not causing a problem
maybe open the bottom vent and ensure the cover is seated properly and pump is clear.
also check the outlet pipe is not blocked or leaking and water is running back on the outside of the outlet pipe and under the machine

I hope this was useful.

May 23, 2011 | AEG Washing Machines

1 Answer

I have a aeg lavamat turbo washing machine .when start it the water does not got to the drum ane water never stops simply running

You have a syphon - the waste pipe is probably too low and the end sits in water in the drain, meaning the water runs through the machine and out the waste.

Jun 30, 2010 | AEG Lavamat 12710 Front Load Washer /...

1 Answer

About mid cycle, a significant amount of water leaks out of the bottom. No error message comes up and the machine continues functioning. Machine is AEG oko lavamat 72640

Could the machine be overfilling due to a faulty pressure switch (controls the amount of water in the drum). Splits in the door seal or broken pipes?

Jan 25, 2010 | AEG Lavamat 72640 Front Load Washer

1 Answer

Code E10 shown . Machine is in an outhouse.It's very cold.

Problems during water filling phase – washing
(Machine tries to fill for 10 min without reaching the level)

check pipes are not frozen... and valve is operational... should buzz when calling for water....

Jan 04, 2010 | AEG Washing Machines

1 Answer

Water is coming out of the wash powder tray. I had recently detched this and cleaned it

you need to check all your drain pipes as mine was blocked down into the drain itself

Nov 21, 2009 | AEG Lavamat 72640 Front Load Washer

2 Answers


fit hoses at random. put on a rinse cycle. if cold water comes in then hoses are correct. if hot water comes in, then reverse hoses

Aug 22, 2008 | AEG Lavamat 72640 Front Load Washer

3 Answers

Washing machine AEG 72620 not functioning.

Having worked for AEG for over ten years, the fault is a faulty dispenser unit ( top of soap draw) only fix is to replace the unit ( cost approx £45)

Aug 29, 2007 | AEG Lavamat 72640 Front Load Washer

1 Answer

Aeg washing machine

you may have blockage in pipe from drawer to tub but more likely the soap drawer is clogged. take it right out and clean thoroughly

Mar 21, 2007 | AEG Lavamat W1050 Front Load Washer

1 Answer

Washing Machines slowly fills with water over a few days

could be leaking inlet valve or if drain is plkumbed in unbder sink, could be filling thro drain pipe when you emptyt sink

Mar 17, 2007 | AEG Lavamat 16810 Front Load Washer/Dryer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides