Question about Sony KDF-E55A20 55 in. LCD Television

4 Answers

LOST ALL POWER

I was watching a game and just lost all power. Now it won't even power back up. In the bottom right corner there is a green light that turns straight to red and you get no sound or picture. Can anyone help?

Posted by on

Ad

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

If it blinks 6 times, it's supposed to be your thermal fuse that needs to be replaced. I have my TV taken apart waiting the for the part to come in.

Posted on Jan 15, 2008

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I want an answer to this same problem myself ?

Posted on Jan 14, 2008

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Same thing with mine. Blinks 5 times

Posted on Jan 11, 2008

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 43 Answers

How many times does the light blink red? It should blink so many times then stop then blink again. What's the sequence? This will help me determin where the problem is.

Posted on Jan 06, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My hitachi 1999 tv turns on but off right away has flashing green lights in back


If the flashing green lights are on the circuit board each is tied to a voltage from the power supply----likely damage is there but a 99 may not be economical to fix in 2012.

Nov 04, 2012 | Hitachi Televison & Video

1 Answer

Phillips


The main power regulator board is faulty. It should be replaced.

Aug 13, 2012 | Televison & Video

1 Answer

I have a WD62825, it lost power while watching. There is power at the plug in.


Is the grreen light on?..or can be switched on via remote? Plug it out then back in. Green light flashing? If so...you have lost input signal or the tv has reset itself to another input (non functioning). Use Remote to set input (via Net Command) to functioning signal. If the Green light NEVER comes on...it may be major system failure. Be sure remote is set to "TV"

Jun 22, 2009 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

No power, lost power while watching tv


after picture is lost, does the screen remain lighting?

Jan 13, 2009 | Philips Magnavox 50ML8105D 50" HDTV DLP TV

1 Answer

How do ya reset fuser code (H-4) Xc1044 Xerox?


Performing a Fault Reset 14 will reset your copier and will help to clear error codes.
  1. Turn the power off.
  2. Locate the Clear Button, which is grey in color, in the upper right corner above the green Start Button.
  3. Locate the Auto Button the lower left corner of the Control Panel.
  4. Turn the power back on.
  5. Press the buttons in the following sequence, releasing each button after each time you press it: [Clear], [Auto], [Clear], [Auto]. Every light on the Control Panel should go out, and the error code should clear.
  6. If the error code has not cleared, wait a few seconds then repeat Steps 1 through 5.
  7. Program the copier as if you were going to make 14 copies.
  8. Press the green [Start] button to store the reset code. The copier will return to the ready position.
  9. Run a test copy.

Nov 26, 2008 | Xerox Office Equipment & Supplies

3 Answers

E 73


General Hardware Error: Ethernet port... this error is caused by a problem with the Ethernet port.

Good Luck

Nov 04, 2008 | Microsoft Xbox 360 Console

4 Answers

Lost all Power to TV


My TV did the same thing today. My red light blinks 6 times. Any help would be much appreciated!

Jan 05, 2008 | Sony KDF-E55A20 55 in. LCD Television

1 Answer

Lost power


The symptom you have needs to be looked at by a qualified technician for proper diagnosis. There are 9 LED`s ( 8 green, 1 red) in the power supply that light up under normal condition. These LED`s are used to help pinpoint the area of trouble. For example, when power is applied all LED`s but one lights up. The unlit LED may indicate the +27 volt source is bad. That will alert the technician to check components related to the +27v line. Since there are 8 green LED`s and 1 red, each having multiple suspects leads us to Mr Spock`s comment to captian Kirk." there are endless possibilities"

Nov 14, 2007 | Hitachi 50UX52B/53K 50" Rear Projection...

Not finding what you are looking for?
Sony KDF-E55A20 55 in. LCD Television Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75846 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...