Question about Philips 60PP9363 60" Rear Projection HDTV-Ready Television

1 Answer

51" Magnavox projection TV

Hi, we have a 51" Magnavox projection TV. It is almost 2 yrs old. The sound still works on it, but one day the screen just went blank and now there is no picture. Does anyone have any suggestions as to what may be the problem? Or has anyone else had this issue with theirs? THANKS I am having the same problem....I have sound but no picture. It just happened while we were watching tv. I was told it has something to do with the CRT's not getting enough voltage. Can someone suggest what to do and if I can get the parts to fix it.

Posted by on

  • Anonymous Jan 15, 2008

    same here but we have chirping, about 90 chirps a minute,,,any ideas?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Philips Master
  • 3,459 Answers

I had the a similar issue. My TV broke - no sound and no video but the power light was still on.

I gave up and called in a repair tech.

He fixed my TV in less than 30 minutes by replacing a bad IC chip. He informed me that this is a very common problem with the older Magnavox TV sets and that its typicaly the same chip that fails.

I spent over 300.00 for the repair. The parts cost less than 20.00.

To help others in the same boat I put together a how to guide and parts kit on .  I'm not sure if it will work for you but it may be worth a shot.

Posted on Jul 05, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 42 in. 42HP66 Toshiba Plasma TV popped and screen went blank

One of your y driver almost go bad. For your future problem please visit my site at

May 07, 2010 | Toshiba 42HP66 42 in. LCD Television

1 Answer

The t.v.just went blank while watching it.

Power boards are like time bombs. When it's time is up, it's up. Since it is 3 yrs old, I would buy a new tv. Most TV parts only last 3-5 years anyways. It did a good job.

Nov 14, 2008 | Televison & Video

1 Answer

60" Rear Projection TV

sounds like a convergence chip problem...

here is my general post for the 51 inch you'll have to look at the link for the manual and check to see if you have the STK392-120 chips or somthing bigger in the 60"

you need 2 Convergence IC's STK392-120's (120's and 150's will work) of course order 2 of the same type I'm using replacement 150's they allow for a little higher heat and were cheaper ALSO you need to replace the 12 resistors with 6.8 ohm metal film resistors, make sure they are metal film! don’t skimp out here I did and then they blew and fried my IC's and I had to replace everything again!

Great reference link that I posted
pictures on, check out page 3

Where I got my parts that worked:
Suburban Electronics
Manual Library you should find all you need here:

What you need:
(2) STK392-120 OR STK392-150 IC
(12) 6.8 Ohm Metal Film resistors
set of star screw drivers
15 watt pencil solder pencil, DO NOT use a high watt iron you will fry the surface mounted item.
good leaded solder, and flux

Aug 21, 2008 | Philips Magnavox 51MP392H Rear Projection...

2 Answers

Magnavox 51" Rear Project Red Streaks

Sounds like the convergence IC's went south.  

Jul 19, 2008 | Philips Magnavox 9P6034C 60" Rear...

1 Answer

Sony KP-41S3U

Good Day;
On that model look for a small yellow cap, half the size of coin, dime. LOOK very closely and you will see a small burnt spot on the cap. The TV uses about 4 of them, they are 120/110 @ 2 kv. There are located in the high voltage circuit.
This the most common, it could be flyback or HV devider.
Good Luck and Day, big irish.
LET ME know.

Jun 07, 2008 | Sony KP-51HW40 51" Rear Projection...

1 Answer

51" Magnavox projection TV

same with mine. Two things that they have to install and they need the whole tv there to fix it and run it for a week. Cost 500.00!!!

Aug 20, 2007 | Philips Magnavox 51MP392H Rear Projection...

3 Answers


Hi, I am having the same exact issue with mine. Although, it is only about 2 yrs old. We are still trying to find out what is wrong with it.

Aug 01, 2007 | Philips Magnavox 51MP392H Rear Projection...

3 Answers

Magnavox 51" TV Screen

take the broken piece to the hardware store and have a piece of plexiglass cut the same size. thats what we did and it worked really well.

Jan 31, 2007 | Philips Magnavox 51MP392H Rear Projection...

Not finding what you are looking for?
Philips 60PP9363 60" Rear Projection HDTV-Ready Television Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74999 Answers

matt martin
matt martin

Level 3 Expert

1213 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Philips Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides