The dvd player will not eject the dvd

Hi, For some reason the disk will not play. You push the eject button over and over again, but the disk slot will not open. Here's one solution...
* 1 Turn off the DVD player. Wait a few minutes, turn the DVD player back on, and
then press the "eject" button. If this does not work, turn it off and unplug
the DVD player...while you keep pushing EJECT button plug the DVD and turn it on (your hand still on the eject..) is should come out..
* 2 ..if it does not eject , unplug the DVD player again, Remove the screws off DVD on the sides and take off the DVD casing.
* 3 Look for the DVD holder inside the DVD player. This device holds the DVD in
place while the DVD player reads the disk.
* 4 Push the stuck DVD disk toward the front of the DVD player until the DVD
ejects. Remember the DVD player is not on and some force ( gentle ! ) must be applied.
* 5 While it is open,plug it on and place a DVD disc just to see if mechanism works properly..
* 6 Replace the casing and the screws. Plug the player in and turn it on. Put
another DVD in to test whether the player is finally working ..
Hope this helps!..
Take care and please Remember to rate/vote and give us 4 Thumbs Up
to continue for Helping out the Community :)
.

Pull the power plug from the unit. Wait a minute, then plug it back in. If it still won't open, you'll have to take the player apart to get it out, UNLESS it has the eject port on it - some do. Look around the DVD drive for a small hole, about the diameter of a paper clip. If you find one, straighten a paper clip, unplug the player from power, then use the straightened paper clip by pushing it straight in to the hole, which should trigger the emergency release.

Good luck.

You may need to try a DVD+R disc. Some of the players/recorders are REALLY picky.

I think your DVD player is trying to read the disk, but it can't. Try unplugging the unit. Holding down the eject button and plugging it back in. After it begins to to power up you can release the eject button. What your wanting to do is to get it to eject before it tries to read the disk. Good luck.

turn the unit on, set to dvd and turn off. then press the dvd open/close button, it should turn on and open without reading the disc.

Quick trick

First let's find out if the motor is dead or
the magnetic clamp is to strong for the motor.

Press eject then listen closely for the sounds of struggling motor
if you hear it trying SLAP the top right over the DVD drive
and that should break the magnetic seal and release the tray
you may have to try a few times Press eject and open hand slap kinda
hard the top of the DVD drive , don't worry you won't hurt it.


if that works email me and ill tell you how to fix this.

Rob
rsheehan@northernsteeldesigns.com

how do you copy vhs to dvd on this machine?

TRY UNPLUGGING THE UNIT FOR A FEW MINUTES.SOMTIMES THIS WORKS.

Just next to the eject button on the actual recorder there should be a tiny pinhole.  If you use a small paperclip and insert it, then push, you should be able to manually eject the DVD.  Hope this helps!

You must push and hold power and dvd eject at the same time.