Water is coming from under the washing machine not

take the back off, check the hoses up top coming from the little dispensers. if one of the hoses is broken, that will be where the water is leaking from.

There might be two possible reason for that.

it might be coming form the tub itself passing through the rubber seal of your plastic rotator(the big wheel inside the tub)

the other thing is in the junction of the hose the tub.

try to open the back of your washing macjine where you can get an access inside the wheel and the junction connector, from there you will the cause of the leackage. try to put some water while looking at so you can see where the water is coming out

If the washer leaks all the time, check these:

• Water inlet valve If water drips even when the washer is off,check the water inlet valve. It is located inside the washer at the back of the unit. The fill hoses are attached to it. Replace if deemed necessary.
  
• Water fill hoses Check the water hoses from the household plumbing. Tighten it or replace it as necessary..
• Main tub seal It is located between the transmission and the outer tub. To see the leak, fill the machine with water with small amount of detergent then open up the machine's main access panel.. The leak appears at the underside of the outer tub, at or near the center. The seal is difficult to replace and you probably should call a qualified appliance repair technician.
• Pump You can spot the leak when the tub is full of water if the pump leaks. The pump has two or more black rubber or plastic hoses attached to it and usually has a drive belt that spins the pump. Replace it as necessary if it leaks.
• Outer tub The outer tub can rust, split, or be punctured.You may have to replace the entire tub but its not economical repair to do. Consult a qualified technician for details.
  

If the washer leaks only during the fill cycle, check these:

1. Air-gap device It is a small device found on most washers that prevents the wash water from being siphoned into the household water supply. It is located either mid-way along or at the end of the black rubber hose that comes from the water-inlet valve. It is usually made of translucent plastic. If one of the air-gap components deforms or cracks, you have to replace it.
2. The tube It is a rubber tube that runs between the water-inlet valve and either the air-gap or the inlet spout. If it cracks or breaks, it can cause a leak.
3. Inlet spout It is a plastic spout found on most washers near the top of the main clothes tub that directs the water into the tub. If the spout cracks or breaks free of its mounting, it can cause a leak.