I have my albums all coming up with zig zag white lines in each and every picture

There is a dial or a lever that you turn it to. It usually has a straight line picture for straight stitch and a zig zag photo for the zig zag stitch.

You have the machine set for blind hem stitching. Change the stitch selector to stretch stitch, which is a single, in line stitching zig zag stitch.

Cheers,
Embroidery Services
San Diego, CA

Sounds like you have power saver turned on. Go into "display properties" under "control panel". Go to "screen saver" Check your "Power" settings. Un-check "Hibernate" or look and see power settings are and adjust accordingly. If they are all turned off, check your BIOS settings on your PC. It mights have a power saving feature in there.

Look for bad caps, see example here: http://s807.photobucket.com/albums/yy352/budm/Viewsonic%20VX2235W/

that is the symbol for a paper jam. the figure 8 represents the rollers and the zig zag is the crumpled paper.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/charles_45d8d6c78cd9f0b6

Sounds like the flyback transformer is bad. couple of 100 dollars if it is that

It sounds to me like you're describing the re-trace of the unit. It is repairable, and more so the sooner you get it to the repair facility.

If it is a horizontal line is straite or zig zag, if it is straite then problem in your vertical section,please check the supply of vertical section or output ic of vertical, if it is zig zag line then it could be dry solder in the yoke connector or vertical yoke open, please let me know the vertical ic no.

when you say distorded, is it like a 3-d effect? or more of zig zag type lines in the picture. If there are color outlines like a 3-d effect, then you are having a convergence preakdown, and are going to need to have the convergence IC's replaced. if the problem is the piture is zagged edges and zig zag, lines or a smearing effect, most likly it is the PIP modle is going bad, and even if you dont use the PIP, the video still goes through that module. If it does not have a PIP feature, then there are bad capacitors in the sweep power supply and the problem will get progessivly worse till the set wont come on anymore. Hope this helps. Good Luck