Question about Asko W6021 Front Load Washer

3 Answers

Front drain plug

My Asko W6021 drain plug wil not open. It turns and is stuck in. The cycle of the machine was interrupted as it would not drain, I beleive if I can open this plug all will be fixed. I have drained the water out via the little drain hose in this area.

Kind thanks

Posted by on

  • edda Jan 22, 2008

    I have similar problem I think, it works fine before it's time to drain, or we choose drain cycle. It starts clicking, sounds like its trying to use the pump but it cannot, we opened the front little window at the bottom of the machine, found few coins, but its still doesn't work. Any suggestions?Thanks.

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have similar issues with my Asko W660. Once it was a key stuck between the inlet to the pin trap and the trap itself. I got it out by jiggling and poking into the trap area with a narrow strip of plastic. Mostly, though, it just requires a stronger grip on the door to the pin trap--the little handle is slippery, and hard to get a good grip on. Try making a grip out of a piece of duct tape, or grabbing the handle with pliers.

Posted on Mar 15, 2008

  • Catherine Richards
    Catherine Richards Aug 14, 2016

    I have gotten an F3, manually drained and tried to remove the pin trap knob/plug but could only get the 'outside' knob off...the interior knob doesn't seem to have any way to get a grip..and has white grease or lubricant of some kind on it..is this the bit that you are all saying to grab with some pliers? if yes , then is it just a pull out or does that one also have to unscrew. The manual does not say anything about two access plugs...i don't want to break something !!

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Mine did the same thing, just grab it with a pliers and gently pull it out after you have un-twisted it.

Posted on May 10, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 105 Answers

You have a blockage in the pump
probable nail or screw
try removing the pump
that is taking it off machine and removing obstruction that way
normaly the front pump cover screws off anticlock wise

Posted on Jan 05, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I accidently push the start button when I mean to push the key button to open the door, the cycle will start again. Is there any way to stop it?


Push and hold down the start button again. The machine will stop. Turn to Spin (to drain the water that burped into the machine when you turned it on by accident). Hit start, let the drain and spin cycle complete. Hit the key button and you're all set.

Sep 24, 2011 | Asko W6021 Front Load Washer

1 Answer

My Asko W6021 won't start and the door won't open when buttons are pressed, although the power appears to be on (the red light comes on after power button has been pressed)..


Open the drain hatch at the bottom left of the machine. Open drain pump and check to make sure tat there are no foreign objects in drain pump. Object in the drain pump will prevent the unit from operating properly. If there is water still in the unit, you can use the drain hose to drain the washing machine. If you would like to open the door manually, disconnect power, remove screws holding red plastic handle in place. pull handle.

Mar 15, 2011 | Asko W6021 Front Load Washer

1 Answer

I have an ASKO W6021 Quattro 1200 RPM. It does not complete the wash cycle. If I turn the know to rinse, it does rinse and completes. I tried it without any clothes in it and it does the same thing. I also...


Check that the cold water is turned on. The washing machine uses cold water to rinse, and if the cold water is not on, unit will end without completing cycle.

Mar 14, 2011 | Asko W6021 Front Load Washer

1 Answer

I have an asko w6021 washing machine that won't run. All it does is when the power on button is pushed, and nothing else, it makes a humming sound almost like it's in the middle of the wash cycle. Also you...


Open the hatch at the bottom left of the unit. If there is water still is machine, remove the drain hose and drain machine. Open the drain pump and check for foreign objects, make sure that the rotor spins freely and that there is nothing holding it. This will prevent the machine from working properly

Mar 13, 2011 | Asko W6021 Front Load Washer

1 Answer

My Asko Front load washer model W6021 Prewash


hi you need to replace the inlet valve,take off the top panel and you will see the valve behind the soap drawer with the black hoses.you can get a book from asko.com.au

Jun 15, 2010 | Asko W6021 Front Load Washer

2 Answers

Water doesn't drain


you could have a bad drain pump.
have you checked the hoses that come from the bottom of the tub to the drain pump for anything that might be stuck in there,also check the hose that comes off the drain pump to the wall and look for an obstruction.

Jan 31, 2010 | Asko W6021 Front Load Washer

1 Answer

Asko Washer W6021 Problem


CHECK THE BRUSHES ON THE MOTOR, FOR BEING WORN DOWN!
REGARDS........TREVOR. FLEETWOOD UK.

Mar 09, 2009 | Asko W6021 Front Load Washer

1 Answer

Follow up to asko w6021


try replacing the pressure switch i have had this fault before.the rear sensor supplies the correct water level,the front switch controls the heating and spin cycle.keep me posted.Iwork for asko i will speak to tech support on monday and let you know thanks.

Mar 29, 2008 | Asko W6021 Front Load Washer

1 Answer

Asko W6021 front load washer door stuck! If any one can help me please do thanks, Dwayne.


there is a little red loop that you can pull on to release the door manually. it is located behind the little door on the lower left of the machine. Pop that door open and take the phillips head screw out of the lever hen pull on it and the door will open.

Oct 24, 2006 | Asko W6021 Front Load Washer

Not finding what you are looking for?
Asko W6021 Front Load Washer Logo

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Asko Washing Machines Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you an Asko Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...