Question about Panasonic PT-56WXF95 56" Rear Projection Television

1 Answer

Replacement lamp - Mitsibushi

We just replaced our lamp in our rear projection tv and it will not turn back on (the yellow lamp light is on and the red light blinking, just as it was when the lamp went out). We have unplugged and plugged back in the tv a couple of times but it still will not work. Any suggestions?

Posted by on

  • Libbygray Jan 05, 2008

    thanks so much for your quick feedback. We tried that but it did not work. It is wanting to turn back on (and the green light comes on initially), but then it shuts off and the red light comes back on. Any other things to try?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 373 Answers

Did you get the lamp door back on properly? There is a switch that when the door is taken off the switch there keeps the set from coming on.

Posted on Jan 05, 2008

  • TV Doctor
    TV Doctor Jan 05, 2008

    I have tried this in some tv's like this: On top of the lamp case portion there is a thermal cutoff just like ones that are in microwaves. It has two wires going to it and lies flat on its mount and I have placed a jumper across it or uses an alligator clip lead (has clips on each end with wire connected to clips.) If bad it has opened up and will not allow voltage to flow. Can usually be checked with ohm meter with one of the wires loose if you don't use the jumper. Another problem that comes to my mind it you might have to reset the lamp timer in the service menu. (in some cases) I'm sorry but I don't have this information but you could call Panasonic customer support and they should help

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I've replaced the lamp for my panasonic 50DL54J. When i try to turn the tv on, the power button blinks green, then turns yellow, then the lamp red light blinks..and turns off. Can you please help?


some times when the lamp is not sitting in place it will give you this problem. removed the lamp, put it back and make sure it goes all the way in. close the door and attach screws if any. remember if the lamp door is not close, your tv will not turn on. had the same problem until i reseted the lamp in place. good luck

May 13, 2011 | Panasonic PT-50DL54 50" Rear Projection...

1 Answer

LG RU-44SZ63D turned off while watching, heard click noise


Problem is either you need to replace Lamp or your Lamp Fan is defective. For Lamp Call Mats 1-800-68-1118

May 13, 2010 | LG RU-44SZ51D 44" Rear Projection...

1 Answer

I have a philips dlp 55pl9773 has one red flashing led on the front when i do a hard reset tv boots up lamps lites led goes from flashing yellow to green for about ten seconds and then back to red flashing...


MY philips tv model number 55PL9773/17 WAS TURNING OFF THE SCREEN AND LEAVING THE AUDIO ON FOR ONE MINUTE. THEN THE YELLOW LIGHT STAYED ON. THEN THE LIGHT TURNED OFF. thEN I TURNED ON WITH THE REMOTE AND THE YELLOW LIGHT TURNED ON AND A FEW SECONDS LATER CHANGED TO THE GREEN LIGHT AND THE TV TURNED ON. AFTER A FEW MINUTES, BETWEEN 10 AND 30 IT DID THE SAME THING. NOW IT IS OFF WITH A BLINKING RED LIGHT PERMANENTLY ON. TO TURN IT OFF I HAVE TO UNPLUG IT FROM THE WALL. I REPLACE THE LAMP A FEW WEEKS AGO AND IT IS FINE.

Dec 01, 2009 | Philips 55PL9773 55" Rear Projection...

1 Answer

Picture loss after picture begins to flash. blue and yellow light


Most likely the lamp is dying. Try replacing the lamp before calling a repair tech. What does the Owners manual say about the blink lights?

Oct 01, 2009 | Toshiba 62HMX84 62" Rear Projection HDTV

1 Answer

Lamp light is still on after replacing bulb lamp


Try removing the filter cover on left side of chassis and cleaning the filter. I had the dreaded yellow/green blinking light , so I removed and put back the lamp (it was ok) and cleaned the filter screen and the light was out, tv came on...all ok!

Sep 22, 2009 | Mitsubishi WD-62725 62" Rear Projection...

2 Answers

I have an LG DLP. that turns off after 15 -30 seconds


If the second light is blinking to orange or red, that is usually the lamp indicator light on an LG DLP tv. That indicates your bulb needs replaced, or something surrounding the bulb has failed (like the cooling fan for the bulb for example) IF you have a spare bulb handy, I'd replace the bulb, keeping in mind if you touch any part of a new bulb with your bare hands, you just cut the life of the bulb by more then half.

Jul 30, 2009 | LG RU-52SZ51D 52" Rear Projection...

1 Answer

Lamp light just blinks yellow after lamp replacement, tv does not turn on


I will recommend to take the lamp out and slide in again, it might be that your TV havent detect that there is a new lamp. By doing this you will reset the lamp timer. If dont work search in your manual how to reset the lamp timer.

Jun 27, 2009 | Mitsubishi WD-52525 52" Rear Projection...

1 Answer

Tv won't turn on


I did a 2nd replacement with an original Panasonic TY-LA1000 Lamp, now my TV works just llike new.

Dec 17, 2008 | Panasonic PT-43LC14 43" Rear Projection...

2 Answers

TV was working earlier, today came home no green power light no nothing


I looked up the manual online - after you replace the bulb, you need to reset the bulb life timer. Using the TV remote push the menu button, SETUP menu, select the lamp reminder option to reset the hours to zero. That might help the status indicators.

Sep 04, 2008 | Mitsubishi WD-62525 62" Rear Projection...

Not finding what you are looking for?
Panasonic PT-56WXF95 56" Rear Projection Television Logo

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Televison & Video Experts

 Grubhead
Grubhead

Level 3 Expert

5554 Answers

Demonic-2011
Demonic-2011

Level 3 Expert

509 Answers

The Knight
The Knight

Level 3 Expert

75846 Answers

Are you a Panasonic Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...