I dont know how to activate the flash - Vivitar ViviCam 5024 Digital Camera

holding down the button on the fob activates it...signal lights should flash twice
press the fob button twice and the lights should flash once , it is then disarmed

My Eco light was flashing fast ,and the drain pump was running continuasly.It turned out at the drip tray was full of water and micro switch add activated . i tipped the machine forward drain the water off the machine as be working fine since. PS dont know why drip add so much water in it, unless theres a leak. ???

You should try installing the flash player from adobe and java machine from sun microsystem, if it's not installed already.
Let me know if you solved this problem

This is regarding the GPRS activity on your phone. You need to deactivate GPRS on your phone.

1. activate bluetooth on handset (phone) then immediately.
2. Press and hold mute switch on wep180 for 8 secs until led flashes blue. Release button only after you see the flashing blue led which indicates the WEP180 is active.
3.Enter the pin 0000 which is the default pin code on the WEP 180 and the handset should connect to your WEP 180 - I dont know how to get it to pair with the PS3.

The PSP doesn't have flash inside the browser.

presssing the SCROLL UP button toggles the flashlight function. if you carry the phone in your pocket, try activating the keyguard function (press "menu" then "*" ) this will prevent accidental activation of any key

I notice your message is from June 2008.
Answer is easy. Activate your ericsson blue tooth feature. Remove facia of Tevion. On back panel is a button 'Pair'. Hold for a few seconds and the red security light will flash rapidly. Send activate message from phone to connext to radio. Enter code when requested 0000. Replace facia panel. Should be working now.

Perhaps you have set the camera to a record mode other than Auto. Twilight mode for example, does not activate flash so as to set the camera on a tripod and shoot dark landscapes.

Check your camera record mode, and use auto or portrait mode, which they usually activate flash when there is not enough light.

Hope this helps.

Here is the solution: Flash cannot be used in burst mode! You must set the camera to single shot mode!

This really surprised me, since in my old Konica Minolta the burst mode did not prevent flash, it just took a single picture if the flash was activated or multiple pictures when the flash was disabled.