There is a pin sticking out of the side of my kitchen aid stand mixer. I cannot move it in or out. So far the mixer is working but when I tilt the head seems a little unstable.
Comments:
Nov 03, 2009
- This made me laugh. Your Mom must have had some Irish in her! Thanks for the making me smile! I needed that!!
Tap it back in. . Are you sure it is not a locking rod.?
Comments:
Nov 02, 2009
- Works for me. It will last another 30 if you keep the meat tenderizer close. oneeiit, reminds me of what my mother ysed to call us kids wh50 yrs ago. In fact she said that to me when I went into the service. she said ejit.
Was this helpful?
Yes
No
1 person thought this was helpful
Asker's Testimonial
"
It worked - I tapped in the pin - nothing bad happened (which I was worried about) - hopefully my mixer will go for another 20 years. thank you
" - oneeejit
Popular Solutions for KitchenAid 325 Watts KSM150PS
The pin that is holding the top to the base ( Ithink that is its job) keeps sliding out when the...
(More)
The pin that is holding the top to the base ( Ithink that is its job) keeps sliding out when the mixer is on and the motor unit has dropped so that the beater grinds the metal from the bowl. I have tried tightening the screw under the motor unit but this seems to make the top drop even lower.
hi, I own a Kitchen aid classic , stand mixer, and the problem I have is, the pin that holds...
(More)
hi, I own a Kitchen aid classic , stand mixer, and the problem I have is, the pin that holds together the motor head to the stand always comes out. Also sometimes when I tilt the motor head I can hear a clicking sound. My Mixer is not even 2 years old. How big of a problem is that and how can it be fixed?
I own a kitchen aid Classic mixer and have used the shredder attachment on a number of occassions....
(More)
I own a kitchen aid Classic mixer and have used the shredder attachment on a number of occassions. Tried to insert the attachment recently and can't get it all the way in. Goes in except for about the last inch, so it will not seat to 'lock' in place. I remember reading this a a common problem, but can't find anything on it. Nothing has changed, no damage, why all the sudden it won't fully insert? Thanks. Chris
I put in a new worm gear that had broken due to a part falling in the mixer bowl. When I...
(More)
I put in a new worm gear that had broken due to a part falling in the mixer bowl. When I re-assembled the mixer it would not start. I put on a new wire plug and still no current to the mixer? The mixer motor was running fine before I took it apart. I had started a few times before taking it apart and the motor ran but the mixer would not turn because the gear was broken. I know the motor was fine and current was getting to it. Is there a reset switch if you take one of these mixers apart?