Question about Standard (CRT) Televisions

1 Answer

I want my own channel on cable

I want to start my own cable channel any ideas??

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 319 Answers
Re: I want my own channel on cable - Standard (CRT) Televisions

All day paint drying channel!

Posted on Jan 02, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

No sound on several channels.

switch the cable box from one tv to another one see if the box you changed works on the tv set you removed the cable box from on all channels if it does work after you swap out the box then it has to be bad!!!

May 12, 2010 | JVC AV-27530 27" TV

1 Answer



I am assuming that your cable is directly connected to the rear of the Magnavox C102 and you are not using any Cable Receiver or Decoder.

If that is how your system is hooked up, then what needs to be done is to enter your menu/setup and select CABLE instead of AIR or STD. Thereafter, channels maybe scanned and saved to the memory.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Mar 19, 2008 | Standard (CRT) Televisions

1 Answer

Toshiba Theaterwide HD TV won't change channel

you will have to program the tv to cable for it to work then it should start changing the channels and if that doesn't work then you might have a bigger problem with the tv

Aug 23, 2009 | Standard (CRT) Televisions

1 Answer

Poor picture quality on Ilo 46'' television

Do you have cable or satellite? Disconnect them and if you currently have free over the air TV and the same problem occurs with these channels, then there's something wrong with the TV. If the problem only occurs on channels with sat or cable connection, then there may be a faulty cable somewhere that can easily be replaced.

If the problem occurs with free channels, one solution (although a long one) would be to unplug your TV completely for about a week, this will reset the TV settings

Feb 14, 2009 | iLO Standard (CRT) Televisions

1 Answer

UHF Tuner

Check to see if the TV/CABLE setting is on CABLE.

Jun 05, 2008 | Sony KV-27V42 27" TV

1 Answer

RCA television suddenly has problems with cable reception

You have a bad ground connection somewhere. Either the cable has a break in the ground side or there is a connection problem elsewhere. Try with another cable if possible.

May 02, 2008 | Standard (CRT) Televisions

1 Answer

TV gets all channels, except 2-6

In most cases when you set your menu ("tuner section") to cable, the tv will pick up all channels, but if you set it to "off air" or "antenna" (or whatever the other choice is labeled), then the tv will only go up to about channel 50 or 60. Are you using cable, dish, or an antenna on top of your house. If using cable or dish, then go into the menu on your tv and set the tuner to "cable". I am pretty certain that your tuner is NOT currently set on "cable" and that also there are no local "off air" channels in your area on 2 thru 6, therefore, you see snow on these channels. I have repaired hundreds of tv's and I feel very strongly that your problem is in your menu.

Mar 04, 2008 | RCA F31317 31" TV

3 Answers

TV contantly searching

the keyboard has bad tact switches or the infrared detector has some issues. you can unsolder the keybard switches one at a time, or you can replace the whole keyboard with some of these models

Jun 16, 2007 | RCA 27F530T 27" TV

1 Answer

Channel constantly searching

#1 resolder cpu oscillator crystal #2 replace eeprom ic. #3 go to service menu set parameter "07" to "00" try one of these steps one at a time.

Jun 16, 2007 | RCA 27F530T 27" TV

1 Answer

Channel selection

What you need to do is take the remote, go into the menu, find channel scan and do a channel scan to find all the available stations available on this system. Make sure the TV set is in the cable mode and not antenna mode or you wont get any stations above channel 13.

Sep 18, 2006 | RCA F27628 27" TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66476 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides