The water does not drain away on my bosch exxcel express dishwasher and a light comes on saying check water

Check the drain pump.If this is fail then you have water inside and the programm never ends.

There is a water inlet valve (lower front service panel) and solenoid located. Check to make sure that there is no blockage, if the main or other tubing entering or exiting this valve is kinked, the machine will display the check water light. There is also a float switch on the inside of the dishmachine, if it is stuck, the light will go off also. Ensure that water is flowing into the machine, and there are no kinks in any of the hoses. If there arent, look into the float. If it is under warranty, do not attempt to do any of this yourself, call for bosch support first.

Carbon brushes in motor worn away, if tripped electrics before problem started could be the motor.

i had this problem,no drain or spin,opened the flap at bottom right hand corner and pulled out small hose to drain machine opened circular filter cover (some water may come out) and found a 5p and 1p blocking filter after removing ,machine worked fine.
hope this helps

Not sure of your light indicator; check the manual. But fyi there should be a little water left in, so the rubber seal doesn't dry out. More than that, and could be clogged drain or bad solenoid, which tells it to open and drain. See: http://www.partselect.com/repair.aspx?appliance=dishwasher&part=water-wont-drain

Make sure the drain pump is clear of any blockages and obstructions and that the drain hose wasn't kinked when you re-installed it.

you have to free the propellor to get it to free spin. there is a screw at the base this will give you access to the propellor.its a torc screw. when you get to propellor spin it with your hand and it will free up.

he there,

sounds like there may be something caught in the drain pump itself.

can you provide me with the complete model # on your dishwasher please?

thanks

**** out the water with a shop vac. Consult manual for self diagnosing keypad codes.

Check first the drain lines and the drain pump.

If the drain pump is working, and there is no problem in there, then the problem is usually because the water level switch activated by the floating sensor is stuck.

You probably need to have the water level switch replaced.

You can find parts on websites below:

You can find replacement water level switch , and schematics on websites below:

BSH - Bosch Customer Service

Appliance411: Repair Parts

how to mend it .com - ~~ Wiring diagram for BOSCH Dishwasher.