My admiral dryer runs but has stopped drying the clothes to where I have to run the load five or six times and when I take out the clothes they are cool instead of warm. It does this with every drying cycle I have tried
either your heat cycling switch,hi-limit switch,thermistor or part of your element is defective or you don't have full 240 volts to operate your dryer i.e. only 1 leg of 120 volts it will run in some cases but will heat poorly
At first the washing machine would overfill on the rinse cycle, but not everytime. At first we...
(More)
At first the washing machine would overfill on the rinse cycle, but not everytime. At first we thought it was a drain problem. Today, it began to overfill on the first washing cycle. The water did not cut off even when it was full and began to agitate. I turned the machine off and the water still began to fill. So I turned off the water line. What is going on?
When my washer gets to the rinse cycle, it stops. You can hear a slight hum and then it goes dead. ...
(More)
When my washer gets to the rinse cycle, it stops. You can hear a slight hum and then it goes dead. After several minutes, you can start the washer again with no problems.