Error Code 08:11 HP z6100 - HP Hewlett Packard Designjet Z6100 InkJet Printer

This error indicates that the vacuum fan is stopped.

Hello. The error message indicates a vacuum fan failure. The problem can be solved by replacing the Vacuum Fan Assembly.

Q6651 60286 HP Designjet Z6100 Vacuum Fan Assembly

The service manual with instructions can be downloaded from: http://www.lpscomputer.com/collections/designjet-z6100-parts

error code 42:10
Electrical fault in Carriage Motor or starting the Scan Axis or Homing Scan Axis.:
it is not uncommon to find that the encoder is the fault behind the error code,
in the User manual there is a procedure for Cleaning The Encoder Strip. you should follow these steps carefully
.A Z6100 User manaul is available to download at HP.com link as follows:-
http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?cc=us&contentType=SupportManual&prodSeriesId=3338748
the user manual is located near the bottom of the page
.

System Error:
46:03

Problem Description:
Primer servo shutdown.

Corrective Action:
Try the following:
1. Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.
2. Replace the Primer Assembly .
3. Replace the PrintMech PCA .
4. Replace the Interconnect PCA .

Hi so no error code? I'm sorry to say without an error code to point to the fault is not not going to be a simple job,
I make a living repairing designjets but I'm not supported by Hp, my best advise would be to email Hp and ask for a Maine agent in your area then pin them down to a price to come out and give you a quotation for the repair on your plotter
Yours Ian
Ps if this has been useful please rate me

Did you manage to fix your plotter after you were getting error code 08,11 as we are getting the same code and can not find the problem.thanks from simon
[email protected]

it contains m/b like desktop with cpu,ram,hdd etc check ram cpu fan & power supply refix them after cleaning ...............may b ur problem will be resolved.

Service Station error. Switch the power OFF from the back of the Printer and disconnect the power cord. Check the Primer Tubes. Reconnect the power cord and power On the Printer. Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. screws, plastic parts, etc...) restricting the movement of the Service Station. If the System Error continues, replace the Service Station. If the System Error continues, replace the PrintMech PCA

01.2:10
Problem
Description:
ISS PCA problem.
Corrective Action: Try the following:
�� Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
�� If the System Error continues, replace the Ink Supply Tubes and Trailing Cable.