Question about Rockford Fosgate 360a2 Car Audio Amplifier

2 Answers

1000 crossfire bmf and a rockford fosgate that need to be fixed

I got a crossfire 1000d and a rockford fosgate 320a2 that need to be fixed i cant find out whats wrong with them ??? i need some help who can fix them???

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert whose answer got voted for 20 times.

  • Expert
  • 149 Answers
Re: 1000 crossfire bmf and a rockford fosgate that need...

Send the rockford to landis technical-they bought up all the parts to rockfords amps and will get them back to factory specs and recertify it for ya along with a new power certificate-look on rockfords website and snoop around and it will break it on down for ya and give you the address n stuff. i had to send my 1501bd mono amp in to get an overhaul and it came back throwin 1810watts rms so that was better than when i started -good luck.

Posted on May 01, 2009

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers
Re: 1000 crossfire bmf and a rockford fosgate that need...

Are you planning on trying to fix it yourself or have someone fix it. and what is the problem with it.....

Posted on Jan 07, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

Schematics for Rockford Fosgate Punch 801s amp

I recommend contacting Rockford Fosgate directly. I have acquired much information feom them iver the years. I've been jamming big car audio since 1983.
A thumbs up would be greatly appreciated if this answer is helpful to you. Rockford Fosgate Car Audio for Fanatics

Jan 22, 2014 | Rockford Fosgate Car Amplifiers

1 Answer

I got a rockford fosgate 801s. and i cant find where the fuse is located.

Regards, Tony

May 22, 2011 | Rockford Fosgate Punch 801S Car Audio...

1 Answer

I have a rockford 500s i need a size for a sealed box for a crossfire bmf w12d. i am putting it in the hatch of a 96 camaro so preferably the smallest one. i cant go on crossfires website i only have my...

If it is a single 12" the rule seems to be 1 cubic foot of airspace. Fill a smaller box with fiberfill
and it thinks it's bigger.
If you want to compensate for the volume taken up by the woofer, you can use the following approximations. Keep in mind that these are for 'normal' woofers. If you're using a competition woofer with a huge frame and magnet structure, refer to the manufacturer for the actual displacement volume of the woofer. Even if you're not using competition woofers, most high quality manufacturers provide this spec in the woofer's datasheet. 8 inch .03 ft3 10 inch .05 ft3 12 inch .07 ft3 15 inch .10 ft3 Also noting that a box that is 12" X 12"X18" should get you in the 1 cu ft range but you may need
to go 14X14X14 or 1.3 cu ft to be able to get the speaker into the box-clearance!
Dont use plywood! It flexes. Use MDF and use a silicone sealer like window or door seal
to make it air-tight. To get more audio out of a small amp, add a port however the calculation
of port size is a bit scarse.
Here is the site I use. Maybe you can write down the www and go view it on someone's computer.
See # 110 on the right side pane. I love this site for all calculations.

Mar 11, 2011 | Rockford Fosgate Punch 500S Car Audio...

1 Answer

I want to hook up a crossfire bmf 12 to my 500s. It is a dual 4 ohm speaker which config will i get the most power out of the amp. Wired at 8ohm bridged or each voice coil on a channel. That amp wont run...

You are correct, the amp will not support 2 ohms bridged. your best bet would probably be to have one voice coil on each channel. You could run them in parallel on one channel. but you will be getting the same power to each sub as if you put one on each channel. If you run them at 8 ohm bridged you will be getting less than 125 wrms per voice coil because of amp inefficiency at such a high resistance. It will sound cleaner also if you have one voice coil per channel.

Mar 09, 2011 | Rockford Fosgate Punch 500S Car Audio...

1 Answer

What is the auctual watts fpr the Rockford Fosgate Punch 401S?

rockford fosgate doesnt have watts its considered monoblock it gives off watever the speakers gives them the power they need

Dec 29, 2009 | Rockford Fosgate Punch 401S Car Audio...

1 Answer

I have one 12inch 1000 watt mtx sub what size amp should i buy

Hello taona80,

If the 1,000 watts is RMS, I'd recommend an amp in the 750-1,000 watt RMS range, perhaps like the Alpine MRP-M1000 or Rockford-Fosgate T1000bd. If the 1,000 watts is peak power, the subs continuous (RMS) power handling is much lower, probably 300-400 watts. In that case, I'd recommend the Alpine MRP-M500 or Rockford-Fosgate T500-1bd.

Nov 09, 2009 | Nitro BMW-482 Car Audio Amplifier

2 Answers

Rockford fosgate amp keeps shutting down when volume is cranked

your cd player cant handle all the power, time to upgrade to a cd player with at least 80w10

Jun 12, 2009 | Rockford Fosgate Punch P5002 Car Audio...

2 Answers

I have a Rockford Fosgate Puch 1000 watt amp "thermal" problem

With your multimeter set to DC volts, the black meter lead on the ground terminal of the amp and the head unit on (so the amp will have remote voltage applied), touch the red lead alternately to the B+ and remote terminals of the amp. If the voltage is below ~11 volts, you need to check the wiring feeding whichever line is too low.

If the voltage remains near or above 12v, disconnect all speaker wires from the speaker terminals of the amp and disconnect signal cables from the amp. If it powers up without the thermal LED being lit, the wiring needs to be checked. If it still indicates that it's in thermal protection, it needs to be serviced. A local repair shop will be the quickest. Rockford will email you the schematics.

Apr 07, 2008 | Rockford Fosgate Punch P5002 Car Audio...

Not finding what you are looking for?
Car Amplifiers Logo

Related Topics:

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rockford Fosgate Car Amplifiers Experts

Pablo Gonzalez

Level 3 Expert

733 Answers

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Robert Rankin

Level 2 Expert

338 Answers

Are you a Rockford Fosgate Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides