Question about Proscan PS36600 36" TV

1 Answer

Power problem when I try to turn it on the the light blinks 3 times there is a loud clicking from the back.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 579 Answers
Re: power problem

This is a serious failure. How old is your TV?

Posted on Dec 31, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

What does it mean when the standby light flashes four times on a Sony TV Model # KV-24FV12 ?

These blinks [flashes] are fault indication (Error Codes).From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it.This will make repair easy.These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times.Count it carefully.If you wish to get some details, check the site linked here.It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
Blinking codes details to many popular brand TVs are given.Surf the site with patience.

Sep 22, 2014 | Standard (CRT) Televisions

1 Answer

Sony FD Trinitron WEGA

Here's my suggestion , unhook all the external components to the TV and leave the TV unplugged for more than a few minutes (a day/overnight). The next day plug the TV into the wall outlet (not the powerstrip) without anything hooked up to it, and turn it on. See if it comes on. Sometimes unplugging for a few minutes/hours is not long enough for it to reset itself.

Dec 28, 2007 | Sony FD Trinitron WEGA KV-36FS120 36" TV

2 Answers

Sony Triniton TV KV 32FS120 will not turn on

In standby mode (red led on/after the led stops from blinking), press "Display", "5", Volume (-)", "Power on" on the remote control in sequence, self diagnostic screen will be display, let me know the what is on the screen to diagnose where the fault came from.

Nov 25, 2011 | Sony FD Trinitron WEGA KV-32FS120 32" TV

2 Answers

When you turn on power you hear a click and the green light turns on. Three seconds later you hear another click and the green light turns off.



PRESS AND HOLD "device"(input) and"menu" buttons on front of tv for at least 5 seconds and then release bothtogether.

Watch for power light to blink in a sequence:

1 blink-then 2 blinks-------no error

2 blink-then 1 blink-------X-ray protection

2 blink-then 2 blink-------SHORT PROTECTION*******

2 blink-then 3 blink---------deflection circuit problem

2 blink-then 4 blink---------vertical circuit problem

******2, then 2 is most common---usually means one of the fuses that protectthe Convergence IC or IC's is blown---set will detect no voltage to convergenceIC and shut down.



let me know what you find--hope that you find 2 blinks, a pause and twoblinks--this is the most common and easiest to fix.

Let me know what you find and I will assist you.


Aug 31, 2011 | Mitsubishi WS-55807 TV

1 Answer

My Sony Trinitron TV 1999 (KV-32V42) made a strange popping sound and I lost both the sound & picture. When I turn it back on, the two red lights on the front of the TV(standby/Timer light & Stereo...


The Standby/Power light of the TV blinks when there is any internal malfunction in the TV. The self-diagnostic function of the TV will cause the STANDBY light to blink or flash when the television detects an issue. The number of times the STANDBY light flashes corresponds to a specific issue.

Few examples are given below; some of the issues may be resolved without the need for service.
1 blink / 2 blinks / 5 blinks: - This indicates that there may be a power-related problem with your set.
3 blinks: - This indicates that there may be a power-related problem with your set. The set will need to be serviced to allow a technician to determine the specific issue that needs to be repaired. If the power light flashes three times in sequence in a Lamp TV, the lamp cover is not securely attached. Reattach the lamp cover to resolve this issue.
4 blinks: - This indicates that there may be a back light or lamp power problem.
6 blinks: - This indicates that there is some kind of audio problem with your set.
7 blinks: - This indicates that there is a temperature problem with your set. Please check to make sure that the air vents on the sides and back of the set are not blocked or clogged and there is adequate ventilation around the television. We recommend that you check and clean the vents periodically to make sure the set receives adequate air flow. If the problem continues, the set will need to be serviced.
8 blinks: - This indicates that there may be a video-related problem with your set. If the flash sequence is not listed above or the light continues to flash, follow the steps below to perform a power reset:
Try the following steps to check if the issue can be resolved.
Turn off the television.
Unplug the television power cord from the electrical outlet.
Let the television remain without power for 60 seconds.
Plug the power cord back into the electrical outlet.

If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.

If the issue continues to occur, service may be required.

Thanks for using Fixya.

Feb 04, 2011 | Sony FD Trinitron WEGA KV-32FS100 32" TV

1 Answer

Tv will not turn on. I hear it click and the light goes on for about 3 seconds then shuts off. I've tried this about 20 times

Please listen and try this:

When the power light comes on and goes off, on the front of the set press BOTH the Menu and Input (Device) buttons at the SAME time and HOLD them both for at least five seconds and then release both.

The power light will blink a two digit error code and will repeat it about 5 times. To get it to repeat you would have to unplug the set and turn it one again etc.

The most common error is 2 blinks, pause, 2 blinks.

Let me know what error code you find and I will direct you as to what it means and what may have to be done.


May 13, 2010 | Mitsubishi WS-65819 TV

2 Answers

I have power but it will not turn on. unplugged from power cord overnight then plugged into wall worked fine until i shut it off again, now it keeps blinking the delay light

go to turn tv on,hear a poping noise,once then tv standby lite blinks 3 times repeatily but no picture or audio.can you help me out with this thank you

Feb 14, 2010 | Sony FD Trinitron WEGA KV-36HS510 36" TV

2 Answers

I have a Sony Wega KV-34HS420 TV that takes several tries to turn on. When I push the power button or remote power on I hear the normal click and the sound comes on for 3-5 seconds but then I hear a second...

Since the set appears to "recover", it suggests either a poor solder connection or bad cap somewhere in the power supply. The 7 blinks indicate the problem circuit is in the horizontal area. Check the regulator (STRxxxx) IC in the power supply. If you do not have experience working with TVs, please refer this repair to a shop. The regulator IC costs around $25.


Nov 16, 2009 | Sony FD Trinitron WEGA KV-34HS420 34" TV

1 Answer

I own a Samsung HL-R5067W 50'' DLP. Set is about 3 years old. Recently I heard a loud pop while viewing, picture distorted, but never went blank. I turned set off. When turned on again a loud whining noise...

Check your color wheel. There is a DIY guide for replacing the color wheel. Mine did the same thing yours is and my color wheel was all busted up. Unfortunately after replacing the color wheel my set continues to do the same thing, but this could mean I need to replace the ballast as well.

Sep 20, 2009 | Samsung DLP HL-P5663W 56" TV

2 Answers

Sony kv-34xbr800

I have the same problem. When using the remote, it makes the clicking sounds like it turns on, then immediately makes the clicking sound of turning off. The LED blinks repeatedly 6 times over and over.
I *did* get it to come back on by holding the power button down for about 5 seconds. Now I'm afraid to turn it off again! :(

Nov 29, 2007 | Sony FD Trinitron WEGA KV-34XBR800 34" TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Proscan Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66587 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Cindy Wells

Level 3 Expert

4722 Answers

Are you a Proscan Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides