Just the other day, my xact8 receiver was tuned in, nothing out of the ordinary. Then, it started to...
(More)
Just the other day, my xact8 receiver was tuned in, nothing out of the ordinary. Then, it started to "download" channels. Although it went through, it only displayed channel 0 (the SID number) and channel 184 (weather/emergency). Since I have a lifetime subscription, this was not acceptable. I turned the unit off, waited a minute, and turned it back on. This time, however, it started to download again, but locked up on 0%. Receiver is about 2-1/2 years old and, until now, has never had a problem. I am almost guessing that the receiver fried (because my antenna is permanently displayed on my dash (with a wide windshield) and is not exposed to the outside elements, nor is it subject to potential vandalism.
I need the color code for a Kraco mdl KGE01G car radio. It has a 9 pin square outlet plug but the...
(More)
I need the color code for a Kraco mdl KGE01G car radio. It has a 9 pin square outlet plug but the wires are exposed are all of a different color. An old radio but it should work. I can wire in behind the plug with power, ground, and speakers if I know the wire code. This way I won't have to tear into the radio and figure the code out myself. Thanks
Xact xtr8 sirius gets good signal but despite several hits from Sirius it will not receive any...
(More)
Xact xtr8 sirius gets good signal but despite several hits from Sirius it will not receive any channels and shows that it rquires a subscription
When I switch on my unit I get a message saying updating channels followed by 100% complete. This is...
(More)
When I switch on my unit I get a message saying updating channels followed by 100% complete. This is then followed by a message saying invalid channel. I then immediately get a message saying 0% complete. I have had this for two weeks. The Sirrius Support are less than useless. help!!!!