I have a Kenmore model # 110.76832500 Gas dryer it will come on and heat for a few minutes and then run cold I have check all the fuses and thermostats in the back 4 in all and 1 in the front next to the burner itself they all check good what else could be the problem
more than likely it the gas coils going bad
or the ignitor make sure the ignitor is readin between 2.6 and 3.2 amps
then make sure you have continutity across the boost and hold coils
if you go to www.appliancepartspros.com
type in your model number
look in the gas controls section
you will see your parts cost and how to order them
Was this helpful?
Yes
No
1 person thought this was helpful
Asker's Testimonial
"
I ordered coils and will update the results
thank you
" - leihsingvict
The dryer starts and turns but never heats ups. The vents have been cleaned and I checked all the...
(More)
The dryer starts and turns but never heats ups. The vents have been cleaned and I checked all the wires. When turned on the second "click" for the heating element never clicks over.
I have a Kenmore Gas Dryer, model 110.73942101. During the start of the drying cycle, the drum...
(More)
I have a Kenmore Gas Dryer, model 110.73942101. During the start of the drying cycle, the drum spins, I hear the click and the glow plug glows, the second click the gas releases and fires. This will happen the one or two more times and then all that occurs is the glow, but no ignition. If I let the dryer sit fora few hours it works fine for the first two or three firings and then the same, glow but no ignition.