- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
try to plug in again...if there's no reaction at all, then the power suply section may checked...(I.C. regulator str.... followed the horizontal output transistor or some of the zener diodes regulator or broken PCB line
It has gone into protection mode. This is caused when a short circuit is detected by the power management system inside the tv.
Try a hard reset: Unplug the power cord for a full 4 hours; then try it again and see if it will clear the protection fault and reset it.
If the reset does not help you will need to have a tech look at the set and take voltage measurements inside to determoine which section of the tv has failed and what components will need replacement.
The cost of repair is always over $150 and could be much more, depending on the specific parts that need replacing. for example, if the convergence ICs have burned out the repair is around $350.
The flashing of the standby light may mean something, but I do not know the diagnostic code RCA is using; most RCA models do not have any diagnostic blink codes in the set.
Hope this helps. Let me know if I can help further.