Question about Kitchen Ranges
Clock on range does not work after power failure....costs around 300.00 to fix..has happened twice..do we really need to fix or can we still use self-clean mode without clock??? thanks
1. Verify error code by pressing and holding CANCEL/OFF key for 5 seconds.
Momentarily (less than 5 sec.) press CANCEL key again to remove error code
2. Press and hold any key for 1 minute until F2 E0 code is displayed.
3. Cancel F2 E0 error code.
4. Program and start the clean mode. Observe to see if door locks. If it does not,
inspect the locking mechanism from the solenoid to the latch pawl and door to
find the cause of the problem. If the door is not locking, then 1 minute from the
start of clean, the F5 E1 code will again be displayed. Steps 1 through 3 will
have to be repeated before another clean can be started.
5. Once any mechanical problems with the latch mechanism have been corrected,
program and start a clean cycle (after, if necessary, clearing F5 E1 error code)
to ensure proper operation of the door lock. Immediately cancel the clean mode to observe proper operation of door unlock
Posted on Feb 12, 2008
We had the same problem as well. everything locked up and the display board went dead. It turned out to be the thermostat in the back. Once that was replaced everything worked ok. . The serviceman told us to pull the oven out from the wall when self cleaning. It is because the heat disapation and air circulation from the oven is very poor when running at maximum temperatures and this burns out components. First check the termostat, which is a $20.00 item.
Posted on Feb 23, 2009
I have the same problem. This is an intermittent problem, maybe once every 20 to 30 starts the clock goes resets and the appliance beeps just like if unplugged it and then plugged it in again. I’m an electrical engineer and this sounds like the microcontroller that runs the appliance is being reset by noise caused by the spark igniters. This is definitely a design problem. Separating the wiring of the igniters and the control board should help. When I get a chance I’ll have to connected an oscilloscope and look at the noise. The control board microcontroller reset pin probably needs an RC snubber or an isolated ground. If /when I find something more definite, I’ll place another posting.
Posted on Jan 18, 2010
When it doesn't heat up,
We have a Frigidaire Range model PLEF398CCC and, as many others here have mentioned, we saw the puff of smoke and the oven nor the front left burner works. The repairman has to replace a EOC on the back of the control panel and another one in the back on the bottom. The total cost for parts alone is $438 then add in the service call cost. THIS IS THE SECOND TIME we've had an EOC go bad for big bucks. The unit is about 5 years old. We're thinking of filling the landfill with it.
Use this for troublshooting:
another testimony to help,
Had the same problem. This solved it for me:
Posted on Jul 12, 2010
Tips for a great answer:
Jul 04, 2014 | Frigidaire PLEF398AC Electric Kitchen...
Sep 19, 2011 | Frigidaire PLES389D Electric Kitchen Range
Sep 16, 2010 | Frigidaire GLGFZ386F Kitchen Range
Jul 12, 2010 | Frigidaire Gallery GLEFM397DS Electric...
Feb 13, 2009 | GE JSP26 Electric Kitchen Range
Aug 22, 2008 | Kitchen Ranges
May 22, 2008 | Frigidaire PLCS389DC Dual Fuel (Electric...
Aug 10, 2007 | Frigidaire FES367 Electric Kitchen Range
39 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: