Question about Kenwood Sirius KDC-MPV6022 CD Player

Open Question

Kenwood KDC-MPV622H3 I recently got back in to town only to find my battery dead. I tried jumping the battery but it would not take the charge so i bought a new one and now my radio will not play cd's i have to enter a code and i dont now what it is. I have all the information from the radio if it helps. It is a Kenwood CD Receiver Model# KDC-MPV622H3 This # is also on it 422-9511-11 It also has No.38001720. If you can help i will greatly appreciate it. Thanks for your time. John

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: Unlocking radio

I have this problem almost everytime I have to do it.  It's such a rare occasion.  If I remember correctly, just press and hold the key that moves you to the next number... the >>| key, I believe.  After a couple seconds it'll beep & open up (provided you have the correct code).

Posted on Oct 23, 2007

Ad
robotek
  • 1512 Answers

SOURCE: unlock code

KENWOOD SECURITY CODE CLEAR procedure


Your radio will require one of the following procedures.

Type 1
During the code request mode, while holding the DISP key depressed, press and hold the Volume UP or DOWN key for 3 seconds (so that “…” disappears).
Then using your remote enter your code.

Type 2
Press the "Auto" button and "Track up" on face of radio at the same time. The four dash lines ( . . . . ) should "disappear".

Then using your remote enter your code.

Type 3
Model# DPX-4020 and DPX-4030
Press and hold the 1 then the 6 preset key (preset keys are the buttons on face of radio for storing you "favorite" radio stations). "C" should display.
Then using your remote, enter your code.


Enter your number from the remote control unit. Your code number is 5227 (KCAR)

* Press numeric key “5” ( 2 times ) and press the Track UP/Next Track key
* Press numeric key “2” ( 3 times ) and press the Track UP/Next Track key
* Press numeric key “2” ( 1 time ) and press the Track UP/Next Track key
* Press numeric key “7” ( 2 times ) and press the Track UP/Next Track key

The security is canceled and the set enters the TUNER mode!

Posted on Dec 16, 2007

  • 132 Answers

SOURCE: stereo code

3. Simplified method of clearing the security code
(K Type only)
1. While the code entry is requested, press and hold the
VOL UP key for 3 seconds while holding the DISP key
pressed. (This should turn "----" off.)
2. Enter "KCAR" from the remote. (Same way as the 01
model)
 Press the 5 key on the remote twice, then press the
Track Up key. (This enters "K".)
 Press the 2 key on the remote 3 times, then press
the Track Up key. (This enters "C".)
 Press the 2 key on the remote once, then press the
Track Up key. (This enters "A".)
 Press the 7 key on the remote twice, then press the
Track Up key. (This enters "R".)
3. The security code is cleared and the unit enters the
ALL OFF mode.
4. If you commit a mistake in the code entry, the unit
enters the code request mode again.

Posted on Jan 02, 2008

  • 6 Answers

SOURCE: kenwood cd receiver KDC-MP436U

u need to reset the sucurity code on the unit, if u bought the unit new .or have the manual, it should tell u how to do this. if not contact kenwood and see if they can help
http://th.kenwood.com/Car_Entertainment/1DIN_Receivers/KDC-MP436U

Posted on Apr 24, 2008

  • 30 Answers

SOURCE: unlock code for kenwood kdc-mp235

This Ebay auction 170150626863 rtcurve.gif s.gif will remove the code for 40.00 including shipping, or you can contact Kenwood at 1-800-KENWOOD (536-9663).
Good Luck.
Leadispenser

Posted on Aug 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Town & Country Van dead battery after short trips


Possible dead cell in battery, most likely a fault in the charging system. First, Jump Vehicle to get started then remove the Negative cable. If the vehicle dies when you take the jumper cables away or when you disconnect the negative cable your alternator or charging system is faulty. If the vehicle runs without battery connected you have a bad cell in your battery, replace the battery.

Dec 12, 2009 | Chrysler Town & Country Cars & Trucks

1 Answer

Hi, my battery went dead, after boosting it my radio needs the code, it has been 3 years since I put it in and I don't remember it can anyone help me with this??? It's a Kenwood KDC-MP532u


If you have never set the code - try KCAR or 1111 as a factory default

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Nov 30, 2009 | Kenwood KDC-MP528 CD Player

1 Answer

Have a kenwood deck, kdc mp642u, battery went dead and know we cant get it unlocked..How do we unlock it?


here is the website to get the unlock code good luck
http://mike-unlockcodes.blogspot.com

Oct 21, 2009 | Kenwood KDC-MP642U

1 Answer

Kenwood KDC-MP5324


call kenwood you need the model and serial number and they may charge $25...

Jan 04, 2009 | Kenwood KDC-MP4028 CD Player

1 Answer

Kenwood KDC-MP438U acts as if there is no power to it,dead nothin


The speaker wires are very sensitive. You need to make sure that they are not grounding out. Once the unit senses this it will shut off. Pull the plug out of the back and start over.

Dec 30, 2008 | Kenwood KDC-MP438U Car CD/ MP3 Player

1 Answer

Kenwood kdc3028 it's asking for a code??


At least its asking for a code, some older kenwoods and sonys had a remote fob arrangement that you had to point at the unit to get it to restart. If it is an aftermarket unit, the code should be in the manuals.

Dec 06, 2007 | Kenwood KDC-419 CD Player

1 Answer

Kenwood KDC-W6527 audio trubles


check all the wire connections in the back, you have a short somewhere

Nov 14, 2007 | Kenwood KDC-MP528 CD Player

Not finding what you are looking for?
Kenwood Sirius KDC-MPV6022 CD Player Logo

Related Topics:

433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenwood Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4944 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

yadayada
yadayada

Level 3 Expert

79865 Answers

Are you a Kenwood Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...