I have the KDF-50a12u and the picture has been getting darker and darker then the TV started to power off randomly then the standby light would flash red/green.
I have now replaced the lamp with a new £160 bulb and housing this has improved the picture 100% however the tv keeps turning off, the standby light flashes red 3 times then green. PLEASE help im pulling my hair out.
Comments:
Oct 19, 2009
- Hi,
Thanks for you help.
I have confirmed by opening a back panel that the lamp door switch is engaged when shut. I should have added that the TV does not power off strait away its normally after 5-10 mins. Any other ideas?
Thanks Again
Chris
Oct 19, 2009
- Hi,
the replacment lamp is a philips one i bought off ebay it has restored the picture to the quality that it came from the sony center in, so i doubt its the lamp also the tv did this before i changed the bulb.
The only difference since changing the lamp is the improved picture.
This is a weird issue as it turns of randomly sometimes after 1 min sometimes after 5.
Thanks
Chris
Oct 19, 2009
- So let me get this right. The lamp i bought today from a shop for £160 is no good?? even tho i asked them several times if this was a sony original and they assured me that the philips components where used in the sony original and that i would have no problems. How can i be sure its the lamp so i have some evidence when i go back to the shop tomorrow.
Regards
Chris
The Ballast sense turn on faulty replace the lamp ballast and the lamp door sense switch, Also some times the heat gererated from the lamp can slighty warp the door causing intermittent door to switch connectivity.
Please recheck Lamp Cover and make sure it is fixed in its space securely as 3 times red blink shows lamp cover error. There is small safety switch in TV cabinet under lamp cover that has to be pushed by lamp cover if it is fixed in its position properly. That switch is not being pressed by lamp cover and causing this error. Thanks.
Comments:
Oct 19, 2009
- I just checked service manual of this TV for 3 times blink error and here is correction.. (I was wrong in first response, sorry for that)
It is not lamp cover error as lamp cover error gives 2 blinks.
3 times blink is Lamp error. (as per service manual) either lamp is burnt out or ballast supply is defective.
Thanks.
Oct 19, 2009
- Is replacement lamp Sony original one or aftermarket/ compatible/ alternative lamp?
Oct 19, 2009
- Yeah, Lamp is cause of this 3 blink error, please install Sony original lamp for TV safety. This alternate lamp is consuming more current then its rating and protection circuit sense it to send error signal to system control. Thanks.
Oct 19, 2009
- Click HERE to see original lamp image and click HERE to see its packing/ box. It is XL-2400 lamp. Please visit nearest Sony Service Center to buy original XL-2400 lamp.
Oct 19, 2009
- oops, links seem broken, Click THIS Sony official link please..
A small white line around 5/6 pixels long and 1 pixel high can appear at any time, and anywhere on...
(More)
A small white line around 5/6 pixels long and 1 pixel high can appear at any time, and anywhere on the screen. It is removed by switching the television or source off and then on again. The set is 18 months old
sony bravia kdl-40z4500 is the software different between sinapore and australia, i cannot tune to...
(More)
sony bravia kdl-40z4500 is the software different between sinapore and australia, i cannot tune to digital channels other than sbs
I have a 1 & 1/2 year old Sony Bravia 40" TV. Model# KDL-40V3000. The screen went blank...
(More)
I have a 1 & 1/2 year old Sony Bravia 40" TV. Model# KDL-40V3000. The screen went blank and the red light flashes 13 times. I had a tech tell me that the circuit board needs to be replaced. The cost for just the board was almost $1400 plus labor to install. More than the orginal cost of the TV. I called Sony and was told I had not purchased the warranty So they did not want to work with me. Last Sony product I will buy but is there something I can do to get it fixed at a reasonable cost and am I getting correct information from the tech?
The picture goes from very good to very "snowy". We thought it might be the cable but...
(More)
The picture goes from very good to very "snowy". We thought it might be the cable but wiggling that did nothing. If we tap on the back of the set it usually clears right up but them goes back to snowy after a while.